655639

Solo 475 Comfort Manual

25
Zoom out
Zoom in
Previous page
1/88
Next page
3 Preparing the device for use
ENGLISH 7
Model 425 Pro, 475 Pro:
The telescopic spraying tube can be adjusted in
length from 50 cm to 90 cm. For this, release the
fastening nut (l) a little, pull out our push in the
inner tube accordingly and fasten at the desired
length by tightening the fastening nut (l).
Pro:
Standard nozzle: high-spray nozzle, adjustable,
brass, order no.: 4074501
Alternative nozzle: flat-spray nozzle 02-F80, brass,
order no.: 4900504
3.2 Spray nozzle, filter element and
filling strainer
A filter element is fitted in the nozzle attachment (f)
upstream of the spray nozzle (mesh aperture:
0.8 mm [0.031"], part no.: 407492225).
Alternatively, the ball valve filter offered in the
accessories with order no.: 4900539, mesh width
0.35 mm can be used.
The backpack sprayer is equipped with a filling
strainer located in the filler neck of the spraying
agent tank (mesh aperture: 2.0 mm [0.079"], part
no.: 420016625).
Use of a genuine filter named above and the
original filling screen, each with the indicated mesh
widths in impeccable conditions is prescribed when
working with the back spray.
In addition to the spraying nozzles listed in chap. 9,
spraying nozzles with a collar height of 2 mm and a
collar diameter of 15 mm with fixed application
quantity, spraying angle and spraying pattern can
be used as well.
Changing spray nozzles and filter element:
See section 6.4
3.3 Trial run
At the start of the spraying season and in frequent
use at least once a month, perform a trial run
according to section 6.2 to check the entire device.
3.4 Carrying straps
The carrying belts can be adjusted to the required
length with clamp sliders.
(schematic diagram / depending on the model)
Pull the loose ends of the carrying straps to tighten
the carrying straps.
(schematic diagram / depending on the model)
Lift up the two sliding clips again to release the
carrying straps.
3.5 Pressure adjustment
The pressure is
adjusted prior to
filling the tank by
turning the adjuster
cap (m) on top of the
pressure tank. Press
down the adjuster
cap and locate the
selected pressure
marker tooth over the tooth on the pressure tank.
Model 425 Comfort, 425 Pro, 435 Comfort:
Should spray pressure in excess of 4 bar [58 psi]
be required we recommend to replace the pressure
valve with the pressure plug (n) (part no.: 4200215)
which is supplied with the unit. Release any
pressure in the pressure tank first before replacing
the valve.
A spanner width of 24 mm is required.
Fig. 22 - Pro
Fig. 23
Fig. 24
425 Comfort,
425 Pro,
435 Comfort
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 475 Comfort at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 475 Comfort in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info