Manual Solo 416 (page 26 of 120) (English, German, Dutch, French, Italian, Spanish)

655787

Zoom out

Zoom in

1/120

3 Safety regulations

ENGLISH 6

3.4 Safe handling of spraying agents

 Avoid contaminating the environment, the mains

water supply and/or public sewer systems with

spraying agent or cleaner!

Ensure to avoid contamination when mixing,

filling, using, draining, cleaning, servicing and

transporting by using adequate procedures and

suitable containers.

 Spraying agents and cleaners must never be

allowed to enter the mains water supply – not

even by back-suction when filling, public sewer

systems, sprayed onto wastelands, allowed to

drain into natural bodies of water or disposed of

together with normal domestic waste. This also

means that appropriate care must be taken

during filling to ensure that none of the spraying

agent is drawn back into water pipes. Spraying

agents and cleaners and any unused leftovers of

spraying agents and cleaners must always be

collected in a suitable container and disposed of

via approved facilities for household chemical

waste. Please contact your local authorities for

information about your nearest disposal facilities.

 Avoid any direct contact with spraying agents.

In case of contact with health hazardous spray-

ing agents, immediately rinse the affected body

parts with plenty of clean water, immediately

change the clothing soaked with spraying agents

and immediately seek medical advice.

 Never eat or drink when handling spraying

agents.

 Stop working immediately if you start to feel

unwell while working, or if you become unusually

tired. Seek medical advice if the condition

persists.

 Never allow children or anybody who is not

familiar with handling this type of spraying agent

to handle the spraying agent.

 Clean the spraying agent tank and all other

spraying agent carrying parts whenever the

spraying agent is changed. To flush out any

residue from the pump and the hose, run the

pressure sprayer with clean water after cleaning

the spraying agent tank and before the next

spraying agent is filled in. This will prevent the

risk of any chemical reactions taking place

between the different substances.

 Never spray in narrow or enclosed spaces –

spraying agents are toxic and there is a risk of

poisoning. Spraying equipment must for

example only be used in greenhouses if

adequate ventilation is provided. Signs must be

put up in greenhouses that have been treated.

Nobody should enter the greenhouse again until

it has been thoroughly ventilated.

 When you have finished spraying, prepare the

device for storage according to section 9.8,

thoroughly wash your face and hands with soap,

take off your work clothing and ensure that it is

washed regularly.

Any unused spraying agent that is left over in the

device could cause corrosion and hence

damage the device. Special attention must be

paid to wearing parts like spray nozzles, filters

and seals.

3.5 Safe handling of the rechargeable battery

and the charger

 The charger must only be connected to a mains

supply with an operating voltage between 100 V

and 240 V AC 50/60 Hz. It must only be

connected using the correct power cable –

according to the country-specific plugs.

- Check that the mains voltage is correct before

connecting the device.

- Use the correct power cable – according to

the country-specific plugs.

- The charger must not be connected to the

mains supply in countries for which no correct

power cable – according to the country-

specific plugs – is supplied together with the

pressure sprayer or in countries where the

mains voltage differs from the operating

voltage of the charger. In this case you should

contact a local SOLO specialist workshop to

enquire about options for connecting the

charger to the mains supply.

 Always hold the body of the plug when plugging

it in and disconnecting it. Never pull it out by the

cable.

 The charger is only designed to recharge the

rechargeable battery that is supplied by SOLO

for this pressure sprayer. Ensure that the battery

is always correctly connected to the charger

before charging.

 Never connect the two terminals of the

rechargeable battery (+ / -) with a conducting

object (short circuit).

 Keep the charger, the rechargeable battery and

all of the electronics well away from splash

water. These areas should only be cleaned with

a dry or slightly damp cloth. Before cleaning,

always disconnect the power plug from the

socket and the charging cable from the charging

socket on the device.

 The rechargeable battery contains dangerous

substances. Never open the battery or the

charger.

 Only use the genuine charger to recharge the

battery.

 The rechargeable battery and the charger must

not be disposed of as normal domestic waste.

Ensure that you take them to an official disposal

facility for electrical equipment.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Solo 416 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Solo 416 Manual

Product: