708705

Solis Vac Plus - 571 Manual

55
Zoom out
Zoom in
Previous page
1/72
Next page
THE CONTAINER WILL NOT VACUUM
1. Check whether the air extraction hose is securely attached to the lid of the
container and the air-extraction opening on the appliance.
2. Press down on the lid or the hose connection to ensure that the container is
airtight.
3. If the container or the adaptor is visibly damaged, change the container or
adaptor. Make sure that the container lid is tight all around.
4. If fluid leaks from the container during vacuuming, the container and it's con-
tents should first be cooled in the fridge.
5. Check the function buttons on the appliance.
6. Check that the edge of the container and the lid are completely dry and that
there is 3 cm distance between the food and the top edge of the container. If
none of these suggestions apply, please contact Solis or a Solis approved service
station.
THE HEXAGONAL CONTAINER IS NOT MAINTAINING
A VACUUM
1. Check that control dial is at the “SEAL” position, before, during and after
vacuuming.
2. Check that the rubber seal is sitting correctly and is undamaged.
THE SQUARE CONTAINER IS NOT MAINTAINING
A VACUUM
Check that the rubber seal is sitting correctly and is undamaged.
109108
THE APPLIANCE DOES NOT SEAL
AFTER VACUUMING
1. In the appliance there is a vacuum pressure sensor. If the pressure is not high
enough, the sealing pressure will not automaticallly start. Check the sealing bar
and the seals for contamination and clean if necessary. Also check that they are
in the correct position and start the appliance again.
2. Check whether the seals are broken or twisted. Put them back in place or
replace them with new ones - Solis or your nearest Solis-service station can help
you further.
3. Check whether the bag has a hole in it. To do this, seal the bag with some air
in it and submerge it in water. If bubbles rise from it, it is leaking, use another
bag.
4. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean
the inside of the bag end, the sealing bar and the rubber contact strip and make
sure that the end of the bag is lying completely flat in the vacuum chamber.
AIR GOES BACK INTO THE BAG
AFTER IT HAS BEEN SEALED
1. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean
the inside of the bag end, the sealing bar and the rubber contact strip and make
sure that the end of the bag is lying completely flat in the vacuum chamber.
2. Some foods produce natural gasses or ferment, such as e.g. fresh fruit and veg-
etables. If you suspect this to be the case, open the bag and check the food. If
it is fermenting, throw the bag away. Temperature fluctuations in refrigerators
can also spoil vacuum packed foods. If in doubt, always throw the food away.
3. Check if the bag has a hole which has let air in. Sharp edges of foods should
be covered or „padded“ with folded kitchen paper, so that the edges cannot
cause holes.
THE BAG BOILS OR DOES NOT SEAL PROPERLY
Should the sealing bar or the rubber contact strip overheat, the bag can melt. In
this case, unplug the appliance, open the lid and allow these parts to cool for a
few minutes.
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis Vac Plus - 571 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis Vac Plus - 571 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info