708705

Solis Vac Plus - 571 Manual

54
Zoom out
Zoom in
Previous page
1/72
Next page
107
s
PROBLEMS AND POSSIBLE
CAUSES
THE APPLIANCE DOESN'T WORK
1. Check that the plug is plugged into the correct socket.
2. Check whether the power cable is damaged. If this is the case, bring the appli-
ance to Solis or a Solis approved service centre to get the cable replaced.
3. Check whether the socket is working by connecting another electrical device.
4. Check that the end of the bag is correctly in the vacuum chamber.
5. The vacuum sealer switches off automatically if it overheats. Let it cool down
first before starting to use it again.
THE APPLIANCE IS NOT SEALING AN EMPTY BAG
Check that the end of the bag is lying correctly on the contact rubber, as is
described in section 5 (Page 92).
THE AIR IS NOT COMPLETELY SUCKED OUT
OF THE BAG
1. So that the bag gets completely sealed, the open end of the bag must lie com-
pletely in the vacuum chamber without any wrinkles.
2. Check that the sealing bar and the seals around the vacuum chamber are free
from dirt and in the correct position. Also, the seals must not be broken or
porous. Clean the seals and the sealing bar.
3. Check whether the bag has a hole in it. To do this, seal the bag with some air
in it and submerge it in water. If bubbles rise from it, it is leaking, use another
bag.
4. Use bags and films from Solis exclusively!
5. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean
the inside of the bag end, the sealing bar and the rubber contact strip and make
sure that the end of the bag is lying completely flat in the vacuum chamber.
106
s
CLEANING AND CARE
To clean your vacuum-appliance, please proceed as follows:
1. Always first pull the plug out of the socket.
2. Never submerge the appliance in water or hold it under running water.
3. Do not use aggressive cleaning agents, solvents or abrasive materials for clean-
ing with appliance, these could damage the surfaces.
4. Wipe the appliance with mild cleaning agents and with a soft, damp cloth.
5. Leave the appliance to completely air dry, before storing or using the appliance.
6. The appliance must not be oiled.
• Note: The seals around the vacuum chamber should also be completely dry.
If you take them out for a thorough clean then put them back in place, then
they must be put back in exactly the same position so that no air can enter the
vacuum chamber.
POWER-CABLE STORAGE
If the appliance is not in use, the power cable should be rolled up and placed in
the cable compartment on the underside of the appliance. Never wrap the cord
around the appliance!
s
STORING THE APPLIANCE
• Caution: Before storing, always check that the lid of the appliance is not
locked shut! Otherwise the seals will become no longer airtight.
Store the appliance in a flat dark place, out of reach of children, at best in it's
original packaging. The vacuum sealer must rest on it's base and not lie on it's
side since this could cause damage to the appliance which would not be covered
by warranty.
The upper cover must remain open with the locking catches disengaged. Moreo-
ver, nothing should be placed on top of the appliance so that there is no pressure
on the seals. Seals are consumables and are not covered by warranty.
… 54 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis Vac Plus - 571 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis Vac Plus - 571 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info