Manual Sogo SS-13005 (page 21 of 36) (English, German, French, Italian, Portuguese, Spanish)

798555

Zoom out

Zoom in

1/36

español english français

4. See if electrical outlet is operative by plugging in

another appliance.

5. Twist the Fuse Cap off, then look at the clear

tube to see if the Fuse is darkened. If the Fuse

is darkened, it will need to be replaced with a

standard 10-amp Buss Fuse.

6. If your appliance has a mode switch, make sure

it is set to the correct mode. Refer to the above

operating instructions

7. Make sure bag is placed correctly inside Vacuum

chamber and beneath the air intake.

Air is not removed from the bag completely:

1. To seal properly, open end of bag should be resting

entirely inside vacuum chamber area.

2. Check sealing strip and the foam gasket beneath

the lid for debris and position. Make sure no

breaking or distortion of the foam seal gaskets on

both the cover and on the base around the vacuum

chamber. Wipe clean and smooth them back into

place.

3. Vacuum bag may have a leak. To test, seal the bag

with some air in it, submerge in water, and apply

pressure. Bubbles indicate a leak. Reseal or use

another bag.

4. Uses only the specic vacuum bag with vacuum

channels provided by the manufacturer.

5. Leaks along the seal which can be caused by

wrinkles, debris crumbs, grease or liquids. Reopen

bag, wipe the top inside of the bag and smooth it

out along the sealing strip before resealing.

The machine does not turn to seal after

vacuuming:

1. There is a vacuum pressure sensor built in

this machine. The machine will not turn to seal

automatically if the vacuum pressure inside the

bag is not able to reach to the predetermined

vacuum pressure. Check sealing strip and the

foam gasket beneath the lid for debris and correct

position. Wipe clean and smooth them back into

place, and try again.

2. Make sure no breaking or distortion of the foam

seal gaskets on both the cover and on the base

around the vacuum chamber. Take it out from the

groove, wash and dry it thoroughly; or replace with

a new foam gasket (get it from where you brought

or your nearest service center).

3. Vacuum bag may have a leak. To test, seal the bag

with some air in it, submerge in water, and apply

pressure. Bubbles indicate a leak. re-seal or use

another bag.

4. Leaks along the seal which can be caused by

wrinkles, debris crumbs, grease or liquids from the

bag. Reopen bag, wipe the top inside of the bag

and smooth it out along the sealing strip before

resealing.

Air has re-entered into the bag after being

sealed:

1. Leaks along the seal which can be caused by

wrinkles, debris crumbs, grease or liquids. Reopen

bag, wipe the top inside of the bag and smooth it

out along the sealing strip before resealing.

2. The release of natural gases or fermentation form

foods (such as fresh fruits and vegetables) may

occur. Open bag, if you think food has begun to

spoil, and discard food. Lack of refrigerator or

uctuating temperatures in the refrigerator can

cause food to spoil. If the food which is not spoil.

Consume food immediately.

3. Check the bag for a puncture or hole which

may have released the vacuum. Do not vacuum

packaging hard items with sharp points (like bones

or cracks of nut shell). Cushion sharp edges in the

contents of the bag with paper towels.

The bag melts:

Should sealing strip or sealing element be overheat

and melt the bag, it may be necessary to lift the lid

and allow sealing strip or heating element to cool

for a few minutes.

The canister will not vacuum:

1. Make sure the adaptor was well connected both to

the appliance and the canister rmly.

2. Check if the knob of the canister was on the

position of “seal”.

3. Press the lids OR on the hose adaptor at the very

beginning of vacuuming to avoid leaking from the

cover seal...

4. Check if there are signicant damages or smashes,

if yes, change it for a new one.

5. Check the function of the vacuum sealer.

6. Make sure the rim of the canister is clean enough.

If all the above situations are excluded, please

contact with the appointed service agency.

DISPOSAL OF THE DEVICE

PROTECTION OF THE ENVIRONMENT

At the end of the life of your product, it should go to

a specially adapted waste-recycling centre.

ENVIRONMENT PROTECTION FIRST

1. The symbol on the product or on its

packaging indicates that this product may not be

treated as household waste. Instead it should be

handed over to the applicable. Collection point for

the recycling of electrical and electronic equipment.

2. By ensuring this product is disposed of

correctly, you will help prevent potential negative

consequences for the environment and human

health, which could otherwise be caused by

inappropriate waste handling of this product .For

more detailed information about the recycling of

this product, Please contact your local council

ofce or your household waste disposal service.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sogo SS-13005 in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1.36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sogo SS-13005 Manual

Product: