798726
24
Zoom out
Zoom in
Previous page
1/88
Next page
español english français portuguese deutsch italiano
2.1: Clean the upper filter screen fram
1) Clasp the wedging block of the EVA filter screen
frame with hands. Force down from the outside to
remove the EVA filter screen frame. Unscrew four
screws fixing the EVA filter screen and the rear hou-
sing to remove the EVA filter screen (as shown in
the above figure)
2) Put the EVA filter screen into warm water with neu-
tral detergent (about 40℃ / 104) and dry it in the
shade after rinsing clean.
Unit Storage:
1: Unscrew the drainage cover, unplug the water plug,
and discharge the water in the water pan into other
water containers or directly tilt the body to discharge
the water into other containers.
2: Turn on the machine, adjust it to low-wind ventilation
mode, and maintain this state until the drainage pipe
becomes dry, so as to keep the inside of the body in
a dry state and prevent it from mildewing.
3: Turn off the machine, unplug the power plug, and
wrap the power cord around the wrapping post; ins-
tall the water plug and the drainage cover.
4: Remove the exhaust pipe and keep it properly.
5: Cover the air conditioning with a plastic bag. Put
the air conditioning in a dry place, keep it out of the
reach of children, and take dust control measures.
6: Remove batteries of the remote control and keep
them properly.
Note: ensure that the body is placed in a dry place and
keep all machine components properly.
Troubleshooting
Do not repair or disassemble the air conditioning by
yourself. Unqualified repair will lead to failure of the
warranty card, and may cause damage to users or their
properties. In case of the malfunction, please check the
list below to find out if the problem can be solved with
few simple steps. If this doesnt solve your problem then
take the unit to our authorized service center.
Problems Reasons Solutions
The air conditioning
does not work.
There is no electricity. Turn it on after connecting it to a socket with
electricity.
The overflow indicator displays “FL”. Discharge the water inside.
The ambient temperature is too low
or too high
Recommend to use the machine in at the tem-
perature of 7-35 (44-95 ).
In cooling mode, the room tempe-
rature is lower than the set tempe-
rature; in heating mode, the room
temperature is higher than the set
temperature.
Change the set temperature.
In dehumidification mode, the am-
bient temperature is low.
The machine is placed in a room with an am-
bient temperature of greater than 17 (62 ).
The cooling effect is
not good
There is direct sunlight. Pull the Curtain.
Doors or windows are open; the-
re are a lot of people; or in cooling
mode, there are other sources of
heat.
Close doors and windows, and add new air con-
ditioning.
The filter screen is dirt . Clean or replace the filter screen
The air inlet or outlet is blocked. Clear obstructions.
24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sogo SS-1287 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sogo SS-1287 in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info