785804
10
Zoom out
Zoom in
Previous page
1/37
Next page
87
2.1 Attaching the drive unit to the wheelchair
With a little practice, active wheelchair users can attach the drive unit of the SMOOV O10
themselves while sitting in the wheelchair. Alternatively, the drive unit can be attached
to the wheelchair before the wheelchair user takes their seat. A helper may also attach
the drive unit.
When attaching the unit, proceed (or have a helper) proceed as follows:
Apply the parking brakes to prevent your wheelchair from rolling away inadvertently.
Ensure that both the drive unit and the control unit are switched off. Both compon-
ents may only be attached to the wheelchair if they are switched off.
Hold the drive unit by its handle [4] and slide it under the wheelchair, as lifting the
drive unit could cause the wheelchair to tip backwards!
Lift the drive unit by its handle [4]. This causes the locking claw [9] to open automat-
ically.
Insert the locking claw [9] into the bracket or adapter axle [22] on the wheelchair and
let go of the handle [4].
If the locking claw [9] and the bracket or adapter axle [22] are connected to each
other correctly, the handle [4] lowers to its resting position automatically.
In addition, check that the drive unit is correctly connected to the wheelchair by gently
moving the housing. In this regard, the drive unit must never be held or lifted by the
handle [4], as this will undo the connection. The drive unit must also not be held in
areas close to the drive wheel [8]. This is to prevent fingers being trapped by the hori-
zontally rotating drive wheel, for example.
In these few steps, you have attached the drive unit to your wheelchair. Now it is time to
install the control unit.
Please be aware that lifting the drive unit by the handle [4] opens
the locking claw [9] and the connection with the bracket or adapter
axle [22] is undone as a result!
Apply the parking brakes to prevent your wheelchair from rolling away
inadvertently.
Make sure that the drive unit is switched off. The device may only be
attached to the wheelchair if it is switched off.
2.2 Removing the drive unit from the wheelchair
Active wheelchair users (or a helper) may also remove the SMOOV O10 themselves.
Apply the parking brakes to prevent your wheelchair from rolling away inadvertently.
Ensure that both the drive unit and the control unit are switched off. Both components
may only be removed from the wheelchair if they are switched off.
Lift the drive unit by its handle [4]. This causes the locking claw [9] to open automat-
ically.
Remove the drive unit from the bracket or adapter axle [22]. Slide the drive unit
under the wheelchair, as lifting the drive unit could cause the wheelchair to tip back-
wards!
Put the drive unit down in a safe place where misuse of the device (e.g. due to chil-
dren playing) is ruled out.
Apply the parking brakes to prevent your wheelchair from rolling away
inadvertently.
Make sure that the drive unit is switched off. The device may only be
removed from the wheelchair if it is switched off.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smoov One O10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smoov One O10 in the language / languages: English as an attachment in your email.

The manual is 4.72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smoov One O10

Smoov One O10 User Manual - German - 36 pages

Smoov One O10 User Manual - Dutch - 36 pages

Smoov One O10 User Manual - French - 36 pages

Smoov One O10 User Manual - Italian - 36 pages

Smoov One O10 User Manual - Spanish - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info