332153
11
Zoom out
Zoom in
Previous page
1/12
Next page
22
Instructions for assembly
GB
Working surface cut-out
Cut out the worktop recess accurately with a
good, straight saw blade or recessing
machine. The cut edges should then be sealed
so that no moisture can penetrate. The area is
cut out as illustrated.
The glass ceramic hob must have a level and
flush bearing. Any distortion may lead to
fracture of the glass panel.
Make sure that the sealing of the hob is
properly seated.
The glass ceramic hob is fastened with clips or
with brackets.
Clips
Drive the clips into the worktop cut-out at the
intervals indicated.
It is not necessary to adjust the height due
to the horizontal stop motion device.
Important! The horizontal drive of the clips
must be flush with the worktop (avoid the
risk of breaks).
Position the hob according to the illustration
on the left side (a), align it (b) and insert the
clips (c).
Screws may be used to fasten the clips.
Brackets
Insert the hob and align it.
From the bottom, insert the brackets with
screws in the holes provided for fastening
the brackets, align the brackets and screw
them tight.
Tighten the screws with a hand screw driver
only; do not use a battery-operated screw
driver.
In the case of thin worktops make sure that
the brackets are correctly positioned. A
metric screw must be used on the bracket to
balance it.
Important!
There is a risk of breakage if the hob is
canted or subjected to stress during instal-
lation!
1
Minimum distance to adjacent walls
2
Cut-out dimension
3
Outer dimensions of the hob
4
Cable routing in rear wall
5
Installation height
Dimensions in mm
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg se2732id at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg se2732id in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg se2732id

Smeg se2732id User Manual - German - 12 pages

Smeg se2732id User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info