133128

Smeg kset 910 x Manual

6
Zoom out
Zoom in
Previous page
1/22
Next page
English
Installation
To fix the cooker hood please choose one of
the following options:
a) Fix it to the upper part of the furniture
Figure 3 must be used where the position
of the holes is indicated.
b) Fix it to the internal laterals of the
furniture:
1.- Screw two screws to each side of the
furniture interior following figure 5
instructions. Leave them 3 mm loose for
adjustment.
2.- Screw the provided brackets to the top
part of the hood, keeping the internal
furniture width.
3.- Hold and rise the hood until the slots of
their brackets fit in the screws (step 1)
of the furniture.
4.- Keeping the appliance hold, push it
towards furniture’s bottom until screws
fits into a stable position inside the slots.
5.- Rise the hood a little until a definitive
position is obtained and tight the loosen
four screws to the brackets.
The lower part of the extractor must be
installed a minimum height of 60 cm
above the hob for electric cookers and 65
cm for gas cookers. (If the installation
instructions of a gas cooker indicate a
greater distance this must be observed).
The KSET910X cooker hood only can be
installed in furniture of 90 cm.
Once the hood is installed, the front facia
can be fitted. For this the frontal surface of
the hood is firstly cleaned with alcohol
(manufacturer’s safety recommendations for
the handling of solvents are always to be
followed). Then remove the protective paper
of the adhesive on the fascia, it can now be
placed in its correct position, applying
pressure on the adhesive area.
When the extractor is working at the same
time as other non-electrical cooking
equipment, the outlet air pressure must not
exceed 4 Pa (4 x 10
-5
bar).
To achieve optimum performance the length
of the outlet hose should not exceed 4
meters, or include more than two 90º angles
(elbows)
Although venting to the outside is
recommended, active carbon filters may be
used, which allow the purified air to be
returned to the kitchen through the outlet
pipe.
If you wish to substitute the front panel and
replace it with one matching the kitchen
units, follow the following instructions (Fig.2):
* Withdraw the movable group.
* Remove the screws (T) that support the
front.
* Install the new front fixing it with the same
screws that held the old one.
If something does not work
Before seeking technical assistance carry
out the following checks first:
Om någonting inte fungerar
Innan du kontaktar verkstad gå efter följande
instruktioner:
FEL MÖJLIG ORSAK LÖSNING
Kontakten är inte isatt Sätta i kontakten
Fläkten fungerar inte
Det kommer inte ström i
kontakten
Försäkra dig om att det finns el
Filtret är fullt med fett Rengör filtret eller byt ut det
Tilltäppning i utgångsröret Ta bort tilltäppningen
Fläkten suger inte
upp tillräckligt eller
vibrerar
Fel utgångsrör Kontakta installatören och följ
instruktionerna i denna
bruksanvisning
Lamporna är utbrända Byt ut lamporna
Lamporna tänds inte
Lösa lampor Skruva åt lamporna
SMEG. förbehåller sig rätten att göra ändringar för att förbättra sina produkter om de anser det
nödvändigt utan att detta försämrar produkten.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg kset 910 x at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg kset 910 x in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 4,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info