5
The refrigerator has two front and two rear wheels at the
base of the product on each side that can be adjusted (see
figure A), or four wheels of which only the two front wheels
can be adjusted (see figure B).
If the appliance seems unsteady or you want the doors to
close easier, adjust the appliance's tilt following the
instructions below (depending on the model, as shown in the
figures on the right).
1. Check the installation location to be sure you have at least 1 cm
clearance on all sides including the top.
2. Connect the appliance to the mains power supply.
3. Move the refrigerator into its final position.
4. Open both doors and remove the plinth to locate the levelling bolts
at the left and right of the refrigerator base. The top bolt (1) will
adjust the rear wheel (if provided), and the bottom bolt (2) will
adjust the front wheel.
5. Use the wrench provided to adjust the levelling bolts. Turn the
levelling bolt clockwise to raise the appliance, or anti-clockwise to
lower it.
It may take several turns of the levelling bolts to adjust the tilt of
the refrigerator.
Note: do not unscrew the levelling bolts too much when
lowering the appliance as they could fall out.
Aligning the doors
If, after switching on the appliance and adjusting the refrigerator and
freezer doors, the doors are misaligned, disconnect the appliance
from the power supply and adjust both doors as indicated in the
enclosed diagram.
LEVELLING YOUR REFRIGERATOR
Figure A
Figure B
