360157

Smeg fa 40 x4 inox Manual

5
Zoom out
Zoom in
Previous page
1/23
Next page
5
itting of an angle brace for fixing
In order to prevent a detached larder-fridge
from tilting forward when a filled fridge door is
opened, an angle brace can be fitted.
Fit the angle brace on the wall behind the
cabinet 80-100 mm from the left or right side
of the cabinet depending on which side the
door is hinged.
The angle brace must always be fitted in the
opposite side of the door hinges.
Important!
In case of damage to the power cord it must
be replaced by a power cord of correspond-
ing type, available from the manufacturer or
his service representative.
4. MAINTENANCE
Only use an unscented detergent when
cleaning the cabinet inside.
Switch off the appliance and pull out the plug
when cleaning the cabinet.
The skirting board can be removed to faciliate
a vacuum cleaning of the floor. See fig. (1)
page 20.
Remember to clean the drain in the refrigera-
tor section also.
5. HAS THE APPLIANCE STOPPED
WORKING?
Before calling a repairman, check that
the plug is properly plugged into the wall
socket.
The fuse is intact.
The power has not been cut off.
All controls are correctly set.
Switch off the cabinet for 15 minutes (for
instance at the thermostat). Switch it on
again and after 5 minutes check whether
frost has formed on the evaporator.
Do not open the cabinet when unnecessary.
If the break appears to stretch over a longer
period (over 12 hours) store the foodstuffs, if
possible, in another appliance.
6. SAFETY
Do not store explosive substances in the
refrigerator section, such as gas, cigarette
lighters, petrol, ether or similar.
Scrapped cabinets may become dangerous
to children at play. Therefore, remove the
doors or place the scrapped cabinet in such a
way that children cannot enter it.
7. TECHNICAL DATA
This appliance meets the provisions of the
following directives:
89/336/EEC (electromagnetic compatibility),
73/23/EEC (electrical equipment designed for
use within certain voltage limits) as amended.
Household appliances sold in the EU also
meet 96/57/EEC (energy efficiency require-
ments) as amended.
The rating plate, which is placed either at the
back or inside the appliance, see fig. (5) page
21, provides various technical information as
well as type and serial number.
8. INSTALLATION
See drawings (1) and (2) page 20.
Install the cabinet in a dry place and so that it
is not exposed to direct sunlight or any other
source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The cabinet
should not rest against a wall on its hinged
side. When placing the cabinet on a carpet or
on a wooden floor, the placing should be
checked after a while to see whether the unit
has „subsided“ into the soft flooring.
The cabinets can be built in or put side by
side, see fig. (2) page 20.
For sufficient airflow around the cabinet it is
necessary to have a 50 mm high air duct
right above the appliance, see fig. (2) or an
air duct that leeds the air up over the top
cupboard.
Make sufficient space for door opening, see
fig. (2).
The dimensions for building in are noted on
the drawings.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m above
the floor.
Any local installation rules for appliances of
this kind must be observed.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg fa 40 x4 inox at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg fa 40 x4 inox in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info