682751

Smeg CMS4604NX Manual

18
Zoom out
Zoom in
Previous page
1/32
Next page
18
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground
coee funnel (A21) is not blocked. If necessary, remove coee
deposits with the brush (C5) supplied.
Cleaning the infuser
The infuser must be cleaned at least once a month.
Important! The infuser (A5) must not be removed
when the appliance is on. Do not use force to remove the infuser.
1. Make sure the machine is correctly turned o (see "Turning
o").
2. Open the service door.
3. Remove the drip tray and waste coee container (g.27).
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g.32).
Important! Do not use washing up liquid to clean the
infuser to avoid removing the lubricant applied to the inside of
the piston.
5. Soak the infuser in water for about 5 minutes, then rinse.
6. After cleaning, replace the infuser (A5) by sliding it onto the
internal support and pin at the bottom, then push the PUSH
symbol fully in until it clicks into place (g.33).
Please note carefully: If you encounter diculty in-
serting the infuser, (before inserting it) you must adapt it to the
right dimension by pressing it forcefully from the bottom and
top as shown in the gure 34.
7. Once inserted, make sure the two coloured release buttons
have snapped out (g.35).
8. Replace the drip tray and waste coee container.
9. Close the service door.
Cleaning the milk container (D)
Clean the milk container after each time you prepare milk, as
described below:
1. Lift and remove the lid (D2);
2. Extract the milk container (D3) from the thermal casing
(D6), holding it by the two side grips.
Important!
The thermal casing must not be lled or immersed in wa-
ter: to clean it wipe with a damp cloth.
3. Remove the milk spout (D5) and intake tube (D4).
4. Turn the froth adjustment dial clockwise to the "INSERT"
position (g.36) and pull o.
5. Wash all the components of the frother thoroughly with
hot water and mild washing-up liquid. All components and
the container are dishwasher safe, placing them in the top
basket of the dishwasher.
Pay particular attention to check in the hollow and groove
under the dial (
g.37
) that no milk residues remain: scrape
any residue from the groove with a toothpick.
6. Rinse inside the froth adjustment dial seat (g.38) and the
milk frother connector hole using running water.
7. Check as well that the intake tube and spout are not
clogged with milk residues.
8. Replace the dial, lining up the arrow with the word INSERT,
the spout and milk intake tube.
9. Place the milk container in the thermal casing.
10. Place the lid back on the milk container.
Cleaning the hot water/steam connection nozzle
Each time you prepare milk, clean the connection nozzle (A13)
with a sponge to remove milk residues deposited on the seals
(g.23).
DESCALING
Important!
• Before use, read the instructions and the labelling on the
de-scaler packaging.
• You should use de-scaler authorised by the manufactur-
er only. Using unsuitable de-scaler and/or performing
de-scaling incorrectly may result in faults not covered by
the manufacturer's guarantee.
De-scale the appliance when the display (B) shows message
DESCALING NEEDED PRESS OK TO START (~45min) : to
de-scale immediately, press
and follow the instructions
from point 4.
To postpone de-scaling to another time, press : on the
display the symbol is a reminder that the appliance needs
to be de-scaled (the message will be re-proposed every time the
machine is switched on).
To access the de-scaling menu:
1. Press (B2) to enter the menu;
2. Press (B10) or (B8) until the display shows
DESCALE;
3. Press to start the de-scaling cycle then follow the in-
structions on the display;
4. REMOVE WATER FILTER (g. 39):extract the water tank
(A12), remove the water softener lter (C4) (if present) and
empty the water tank. Press ;
5. ADD DESCALER (UP TO LEVEL A) AND WATER (UP TO LEVEL
B) (g.40); Pour the de-scaler into the tank up to the level
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg CMS4604NX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg CMS4604NX in the language / languages: English as an attachment in your email.

The manual is 13,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg CMS4604NX

Smeg CMS4604NX User Manual - German - 32 pages

Smeg CMS4604NX User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info