Radio operation
TIM Function
(Traffic Information Memory)
With the TIM Function, up to nine traffic
announcements with a total length of a
maximum 4 minutes are automatically
stored by means of a built-in memory.
The recording is automatic if the set pro-
gram transmits traffic broadcasts (recognisa-
ble by the indication "TP" in the display).
Standby Recording
Standby recordings take place when the
appliance is switched OFF for a limited
time.
These recordings are deleted 6 hours after
the time has run down. Switching on the
appliance ends the readiness to record.
2-hour recording
If the TP range was selected before the
appliance was switched off, all following
traffic announcements are recorded auto-
matically in the next two hours. This is brief-
ly indicated in the display by the message
"
TIM 2 h ".
Recording for 24 hours
By pressing the AIM button when the
appliance is switched off, a 24-hour record-
ing mode is activated. The last heard pro-
gram and "
TIM 24 h" are briefly indicated in
the display. If the last heard program was
not a TP program, a TP program is set
automatically.
Information:
• If the memory is full, the next report is
recorded over the first recorded report.
• If a traffic report is longer than four min-
utes, it starts to record over the beginning
of the report recording.
• If the radio is switched on during the
recording of a report, the recording is
stopped.
Traffic announcements played back
chronologically
When the AIM button is pressed, the
most recent report is played back. The
recording number and the time of the re-
spective report are shown in the display, for
example "
TIM 3 15:05". In this way all stored
reports are played back one after another.
By pressing the AIM button again, the
appliance is switched back to the original
state.
Repeating the traffic report
If the rocker button is pressed once
during the TIM playback, the current traffic
report is repeated.
Traffic announcements played back in
any sequence
Press the rocker button briefly twice
during the TIM playback. Now by pressing
the rocker button or you can switch
up and down between the recorded reports.
Fast forward and backward winding
Keep the rocker button or
depressed until the required point is found
in the report.
8
