530441
131
Zoom out
Zoom in
Previous page
1/160
Next page
Fig. 117
Engine earth: START-STOP sys-
tem
Read and observe on page 127 first.
The starting process using the battery of another vehicle requires the use of
jumper cables.
The jump-start cables must be attached in the following sequence.
Attach clamp
1
to the positive terminal of the discharged battery
A
» Fig. 116 .
Attach clamp
2
to the positive terminal of the battery supplying power
B
.
Attach clamp
3
to the negative terminal of the battery supplying power
B
.
Attach the clamp
4
to a solid metal component firmly connected to the en-
gine block or to the engine block itself.
The jump-start cable must be connected to the engine earthing point only on
vehicles with the START-STOP system » Fig. 117.
Starting engine
Start the engine on the vehicle providing the power and allow it to idle.
Start the engine of the vehicle with the discharged battery.
If the engine does not start, halt the attempt to start the engine after 10 sec-
onds and wait for 30 seconds before repeating the process.
Remove the jump start cables in the reverse order as attachment.
Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the bat-
tery supplying the power must not be significantly less than the capacity of
the discharged battery in your vehicle.
Jump-start cables
Only use jump-start cables which have an adequately large cross-section and
insulated terminal clamps. Observe the instructions of the jumper lead manu-
facturer.
Positive cable – colour coding in the majority of cases is red.
Negative cable – colour coding in the majority of cases is black.
WARNING
Do not clamp the jump-start cable to the negative terminal of the dis-
charged battery. There is the risk of detonating gas seeping out the battery
being ignited by the strong spark which results from the engine being star-
ted.
The non-insulated parts of the terminal clamps must never touch each
other – there is a risk of short circuit.
The jump-start cable connected to the positive terminal of the battery
must not come into contact with electrically conducting parts of the vehicle
– there is a risk of short circuit.
Route the jump-start cables so that they cannot be caught by any rotat-
ing parts in the engine compartment.
There must not be any contact between the two vehicles otherwise cur-
rent may flow as soon as the negative terminals are connected.
Towing the vehicle
Introduction
Fig. 118
Braided tow rope / Spiral tow rope
This chapter contains information on the following subjects:
Front towing eye 129
For towing, a braided tow rope is to be used » Fig. 118 -
.
When towing, the following guidelines must be observed.
Vehicles with manual transmission may be towed with a tow bar or a tow rope
or with the front or rear wheels raised.
128
Do-it-yourself
131


Need help? Post your question in this forum.

Forumrules
1

Forum

skoda-citigo

Reset search

  • I bought my 2016 Skoda Citigo two months ago and can't find out why it will suddenly ping for no obvious reason, some times pining three or four time in a row. My partner noticed the numbers 1-5 with an arrow coming up on the right hand side of the odometer but we can't find out what they or the mysterious pinging is. Please can you help. Thank you Submitted on 15-9-2022 at 10:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Skoda Citigo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Skoda Citigo in the language / languages: English as an attachment in your email.

The manual is 12,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Skoda Citigo

Skoda Citigo User Manual - German - 160 pages

Skoda Citigo User Manual - Dutch - 163 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info