634382
19
Zoom out
Zoom in
Previous page
1/30
Next page
| 17
Installation | TP10, TP22 & TP32 User Guide
Conguring the TP on the SimNet bus
Normally the TP22 and TP32 can be connected to the SimNet bus
and will automatically share data sources with other SimNet units
without any required user intervention.
Compass
Autopilot
GPS/Chartplotter
Two operation modes are available:
System mode (default) The Tillerpilot automatically shares data
with other SimNet units.
Source selection can be done from any
SimNet unit using shared data resources
StandAlone mode The Tillerpilot is disconnected from
SimNet, and it will automatically
select its internal heading sensor. The
Tillerpilot cannot be configured by a
remote device.
- To change the mode, first turn off the Tillerpilot
- To select StandAlone mode, press and hold the TACK and
keys
and turn the power on
- To select System mode, press and hold the TACK and
keys and
turn the power on
- The Tillerpilot will beep and all the LEDs will light briefly to
confirm the new configuration
¼ Note: Please refer to the instructions supplied with the relevant
command unit for details on remote configuring of data sources.
Display
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad TP10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad TP10 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad TP10

Simrad TP10 User Manual - German - 30 pages

Simrad TP10 User Manual - Danish - 30 pages

Simrad TP10 User Manual - French - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info