28560
158
Zoom out
Zoom in
Previous page
1/224
Next page
974-25007001/2.0 SL 30/35 Hull Sonar Operators Manual
Page 6.10 Installation, Start-Up and Test
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
6.4.2 Tank Flange and Shaft Prepping
The tank flange comes from the factory with the shaft bearing, grease, shaft seal
and scraper installed at the factory. All tank flanges are serialized and pressure
tested. Great care must be taken not to damage the shaft seals and the flange
gasket surface during the installation.
Calculate the necessary length of the main shaft from the length of the retraction
tank and cut off the extra length if necessary. If you have to cut the shaft, refer to the
shaft drawing located in Part 8 for the proper cutting procedure. If you do not follow
the proper procedure, you will damage the shaft seals and shaft scraper when you
pass the shaft through the main shaft bearing assembly.
See Part 8 “Attachments and Drawings” for the tank flange and shaft cutting
detailed specification.
See Specification for
Proper Machining Angle
SL 35 Shaft
Tank Length - 30cm + 1.3m for 400mm Stroke
Tank Length - 30cm + 1.0m for 250mm Stroke
Supplied length: 2.4m 3.0m or 3.6m
Take care not to damage
during the cutting process
6.4.3 Assembling the Sonar Dome, Shaft and Tank Guide Assembly
After you have prepped the tank flange and shaft length, the next step will be to
assemble the shaft to the dome unit.
Coat the threaded area of the shaft; use the “Loctite” Nickel Anti-Seize supplied
with the installation kit
Coat the end of the shaft with DC 55 O-Ring lubricant
Install the shaft lock nut (screw in all the way)
158


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SL35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SL35 in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info