28560
156
Zoom out
Zoom in
Previous page
1/224
Next page
974-25007001/2.0 SL 30/35 Hull Sonar Operators Manual
Page 6.8 Installation, Start-Up and Test
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
pad is provided on the tank flange and a shaft clamp retainer is included. To mount
the hoist unit just insert the lower and upper locating pins and hair pin clip to secure
the ram in the proper location.
Note: The vent cap must be installed on the oil reservoir to insure proper operation.
A Ram guide is also provided to ensure proper Ram alignment. The Power and
Upper/Lower limit switch connections must be made in the transceiver unit. A one-
meter interconnection cable and crimp-on terminal lug are supplied with the hoist
unit.
6.3.4 Mounting the Motion Sensor
The SL 35 roll and pitch angles motion sensor can be mounted mid-ship, away from
areas subject to water splash. The ambient temperature should not exceed 50
degrees Celsius. Orient the FORE mark on the unit toward the ship’s bow and
mount the unit level to within 5 degrees in all directions. See paragraph. 6.6.11, for
calibration procedure.
Note: 10 meters of interconnection cable from the motion sensor to the transceiver
unit is standard supplied.
6.3.5 Mounting the Tank (Trunk) Unit
The owner and the dockyard, in deciding the location for the hull unit, must conclude
general mounting considerations. When deciding on the proper location, the
following points must be taken in to account:
Noise and air bubbles will affect the performance (bow plane)
Propeller noise (cavitation)
Cruising noise
Acoustic interference
Electrical interference
The location must take into account the interference from other sonar or sounding
equipment. The hull unit must be at least 3.0 meters away from other transducers or
sounding equipment, to minimize interference.
An obstacle in the fore direction will not only cause a shadow zone, but could also
aerate the water, resulting in poor sonar performance. Be sure to locate the hull unit
well away from any obstacle in the fore direction. A typical mounting method is
shown in the outline drawing provided in Part 8 “Attachments and Drawings” for
detailed information.
156


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SL35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SL35 in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info