23336
286
Zoom out
Zoom in
Previous page
1/322
Next page
Simrad PI54
274
850-165186 / Rev.B
(3) = None, one, two or three short flashes: The
number of short flashes signifies the first digit of the
configured channel number.
(4) = A second start flash: This signals that the second
digit of the channel number is next.
(5) = None to nine short flashes: The number of short
flashes signifies the second digit of the configured
channel number.
3 Using a multimeter, check the DC current between the
negative charging lug (A) and the water detector (B).
- With the i nitial sea water switch and a a fully charged
battery, the current should not exceed 150 µA.
- With a redesigned sea water switch (sacrificial bolt)
and a a fully charged battery, the current should not
exceed 67 µA.
- If you measure 0 µA, check the fuse on your
multimeter.
Testing on land
1 Connect the PI Service Hydrophone to the PI Operator
Unit.
2 Place the sensor on a level surface with its “domed top”
pointing towards the test hydrophone approximately five
meters away.
3 Use the Status display on the PI to monitor the sensor’s
signal strength.
- If the interference filter is on, the spectrum displayed
should be relatively flat (approximately 25 dB,
interference filter set at level 9) with a peak detected in
the configured channel.
4 Check that the Catch symbol on the PI is activated (red
symbol and audible alarm) when one of the detector wire
is pulled out.
5 Release the detector wire, and check that the sensor
presentation changes to yellow.
Testing in water
1 Disconnect the PI Service hydrophone, and reconnect the
vessel’s normal hull mounted hydrophone.
2 Switch off the vessel’s echo sounders, sonars and other
hydroacoustical equipment to avoid interference.
3 Lower the sensor over the side of the vessel.
286


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI54 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI54 in the language / languages: English as an attachment in your email.

The manual is 10,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI54

Simrad PI54 User Manual - Norwegian - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info