23326
250
Zoom out
Zoom in
Previous page
1/268
Next page
Simrad PI32
238
857-164636 / Rev.A
Lower the two
sensors as shown,
and make sure that
the Spread sensor’s
head points towards
the vessel’s
hydrophone (C).
Also, make sure that
there is a free line of
sight for the
transverse
communication (D).
5 On the PI numeric display, verify that the reading is +++.
- This signifes that there is no communication between
the Spread and Remote sensors.
6 Lower the Remote sensor (B) over the opposite side of the
vessel with its head pointing in the same direction as the
Spread sensor. Lower it to the same depth as the Spread
sensor, and ensure that there is a free line of sight for the
transverse communication (D).
- If both sensors are suspended under the vessel at its
widest point, the physical distance between the Spread
and Remote sensors is equivalent to the vessel’s
maximum beam.
7 Observe the PI numeric display. The reading should be the
same as the physical distance (without any compensation)
between the two sensors.
Note: Should any problems arise during this procedure, check that the
type (1 or 2), communication channel and update rate have been
configured for both sensors.
8 Switch on the vessel’s echo sounders and other
hydroacoustical equipment used during normal fishing
operations.
9 Switch the PI32 interference filter on and off, and observe
the numeric display. If the interfer ence symbol is not
shown when the filter is off, leave the interference f ilter
switched off to increase the system’s range and
performance.
250


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI32 in the language / languages: English as an attachment in your email.

The manual is 10,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI32

Simrad PI32 User Manual - Norwegian - 98 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info