23326
244
Zoom out
Zoom in
Previous page
1/268
Next page
Simrad PI32
232
857-164636 / Rev.A
8 Switch the PI32 interference filter on and off, and observe
the numeric display. If the interfer ence symbol is not
shown when the filter is off, leave the interference f ilter
switched off to increase the system’s range and
performance.
9 Use a water-proof pen, write the sensor’s number,
configured channel number and any other pertinent
information on its label.
- A dedicated form has also been provided in the front of
the PI Operator Manual to record this information.
Note: Do not write on the sensor! Such information may be
misunderstood when future service or replacement is performed.
PI32 Calibration procedure
Observe this procedure to calibrate the depth sensor using the
functionality on the PI system.
1 Press the Menu button, and select Setup.
2 On the Setup menu, select Sensor alarm/calibration.
3 Press the Enter button to allow the parameters to be
changed.
4 Move the cursor down the Depth/Spread sensor
calibration, and switch Depth sensor calibration to ON.
- If these values vary, calibrate by adjusting the PI32
depth offset function until the measured depth under
the vessel corresponds to the PI32’s displayed depth.
- Another method of calibration is to suspend the sensor
to a measured depth of three meters under the vessel,
and then using the PI32’s depth sensor calibration
functionality. When this calibration procedure is
performed, the offset value will be reduced by two
meters.
PI44 Calibration procedure
Observe this procedure to calibrate the depth sensor using the
functionality on the PI system.
244


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI32 in the language / languages: English as an attachment in your email.

The manual is 10,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI32

Simrad PI32 User Manual - Norwegian - 98 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info