23326
243
Zoom out
Zoom in
Previous page
1/268
Next page
Sensor test procedures
231
857-164636 / Rev.A
(5) = None to nine short flashes: The number of short
flashes signifies the second digit of the configured
channel number.
3 Using a multimeter, check the DC current between the
negative charging lug (A) and the water detector (B).
- With the i nitial sea water switch and a a fully charged
battery, the current should not exceed 150 µA.
- With a redesigned sea water switch (sacrificial bolt)
and a a fully charged battery, the current should not
exceed 67 µA.
- If you measure 0 µA, check the fuse on your
multimeter.
Testing on land
The sensor can only b e tested in water.
Testing in water
1 Lower the Depth sensor over the side of the vessel to a
measured depth greater than two m eters.
- The sensor will not activate if the depth is less than two
meters.
2 Switch off the vessel’s echo sounders, sonars and other
hydroacoustical equipment to avoid interference.
3 Switch off the PI32’s interference filter, and observe the
numeric display.
- If the interference symbol is not displayed, leave the
interference filter switched off to increase the system’s
range and performance.
4 Use the PI32 Status display to monitor the sensor’s signal
strength.
- If the interference filter is activated, the spectrum
displayed should be relatively flat (approximately 25
dB with interference filter set at level 9) with a peak
detected in the configured channel.
5 Check that the depth read-out on the PI32 corresponds to
the actual measured depth at which the sensor is
suspended.
- If these values vary, calibrate the PI32 depth offset. The
procedure is described below.
6 Hoist and lower the sensor in the water, and observe that
the depth readout changes accordingly.
7 Turn on the vessel’s echo sounders as well as other
hydroacoustical equipment used during normal fishing
operations.
243


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad PI32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad PI32 in the language / languages: English as an attachment in your email.

The manual is 10,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad PI32

Simrad PI32 User Manual - Norwegian - 98 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info