39209
75
Zoom out
Zoom in
Previous page
1/122
Next page
Installation
20220760L 73
6.9 IS15 Transceiver
This unit contains the depth and the speed/temperature
electronics. The power supply (battery) and the transducers are
connected to the unit.
The unit has three Roblink connectors for instrument heads and
wind transducer.
Speed/temp transducer and depth transducer are hard-wired to
plug-in screw terminals on the PCB (pwr terminal is fixed).
Remove the top cover to get access to the plug-in terminals.
Press the cable end through an appropriate recess in the
gasket (ref. to Figure 6-5). Remove about 2 cm (0.8”) of the
cable insulation.
Pull out the plug-in terminal before connecting the wires.
Be careful to prepare all wires on each cable before putting it
through the gasket to avoid strands getting onto the PCB.
Insulate the shields by electrical tape or similar.
Make the connections according to the following connection
diagrams.
Leave sufficient free wires so that the plug-in terminals can
be easily connected/disconnected.
Ensure that no strands are left inside the unit before
putting on the cover.
Figure 6-16 IS15 Transceiver PCB - Connector and terminal
location
75


Need help? Post your question in this forum.

Forumrules
1

Forum

simrad-is15

Reset search

  • Simrad is15 multi???
    How do u convert display depth meters to feet?
    Help Submitted on 17-6-2023 at 13:49

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad IS15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad IS15 in the language / languages: English as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad IS15

Simrad IS15 User Manual - German - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info