39207
99
Zoom out
Zoom in
Previous page
1/126
Next page
Installation
20220505H 97
Bring the boat up to cruising speed, and head directly into the
wind.
If the boat has twin engines, synchronize the engine RPM's.
Set the trim tabs and stabilizers to have no effect on the boats
heading.
Steer the boat manually on a steady course.
Confirm the rudder ZERO position by rotating the course
knob clockwise.
The display will then show:
Seatrial
Set Rudder zero
Confirmed 00
Compass
calibration
Compass offset ---
Heading 345
Automatic tuning
No
Yes
Press STBD [>] to proceed to next menu item.
Compass calibration
This function will activate the automatic compass calibration
procedure.
Note ! If an optional magnetic compass is installed and connected to a
CI300X, or if a GYRO compass, or other manufacturers fluxgate
is connected to a CI300X, it is still required to perform the
automatic compass calibration in order to calibrate the CI300X
Interface/input signal.
Before you begin the compass calibration procedure, make sure
you have enough open water around you to make a full
clockwise turn with the boat.
The calibration should be done in calm sea conditions and with
minimal wind to obtain good results. Use about 45-60 seconds to
make a full circle.
99


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info