39207
97
Zoom out
Zoom in
Previous page
1/126
Next page
Installation
20220505H 95
Assign a hardware port to the name by turning the course knob
until the hardware port is displayed along with the name.
Proceed to the names on the list that shall be assigned by
pressing STBD [>] button. Select appropriate hardware ports by
turning the course knob, or exit from menu by stepping through
the list of names by pushing STBD [>] button.
Note ! At the completion of the Interface Setup, the names of items that
you have assigned hardware ports to will be available as
sources of data for NAV (navigation), POS (position) and
COMPASS in the USER SETUP MENU. It is recommended that
you access the User Setup Menu directly after completing the
Interface Setup to select the desired data. Refer to page 31 for
details on changing the items in the User Setup Menu.
INSTR: J300X-1 5/sec
RADAR: ANRITSU
5/sec
1/sec
Output:
Note ! The standard NMEA output rate is 1x/second. When Output
INSTR is set to J300X-1 (default), the output port, TX1, will have
an output rate of 5x/sec. for HDM or HDT (heading) messages.
The output rate may be changed to 1x/second by rotating the
course knob. The RSA (rudder angle) message is always 5x/sec.
Abbreviated
name
Assigned
HW port
NMEA output
rate
97


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info