39207
54
Zoom out
Zoom in
Previous page
1/126
Next page
Simrad AP20 Autopilot
52 20220505H
e) Test NAV mode and input interfaces (if connected)
including optional heading sensors
f) Test interface outputs to external equipment (if
connected)
9. Seatrial settings (Page 96)
a) Set rudder zero
b) Compass calibration
c) Compass Offset adjustment
d) Automatic tuning (Optional: does not need to be done)
e) Viewing parameters
10. Testing Autopilot Operation at Sea (refer to Sea Trial
instructions, pages 96, 104)
11. Provide the user with training (Page 105)
4.3 Unpacking and handling
Care should be taken when unpacking and handling the
equipment. A visual inspection should be made to see that the
equipment has not been damaged during shipment and that all
components and parts are present according to the packing list.
A standard AP20 autopilot system will include:
Control unit with standard installation accessories.
Junction unit (J300X, J300X-40, J3000X) and one 15 m (49')
Robnet cable.
RFC35 Fluxgate Compass with 15 m (49') cable attached.
RF300 Feedback unit with 10 m (33') cable attached and
transmission rod.
Appropriate drive unit for the installation (unless the AP20 is
going to operate an existing drive unit or solenoids).
Optional equipment that may have been ordered for the
installation.
4.4 Determine system configuration
It is important to become familiar with the configuration of the
system prior to beginning the installation. The AP20 system
layout with options is shown in Figure 4-1
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info