39207
53
Zoom out
Zoom in
Previous page
1/126
Next page
Installation
20220505H 51
4 INSTALLATION
4.1 General
This section provides detailed information required to
successfully installing AP20 Autopilot system.
The AP20 system includes several modules that need to be
mounted in different locations on the boat, and also need to
interface with at least three different systems on the boat:
The boat's steering system
The boats electrical system (input power)
Other equipment on board (NMEA interfacing)
In addition, the advanced capabilities of the AP20 require the
installer to perform a series of settings and tests to verify proper
operation of the system, refer to the check list below.
4.2 Installation checklist
1. Determine system configuration you are installing (Page 52)
2. Perform the hardware installation (Page 53)
3. Connect external NMEA devices (inputs and outputs, page
70)
4. Set Language (Page 84)
5. Dockside settings (Page 85)
a) Boat type selection.
b) Drive unit selection.
c) Rudder feedback calibration.
d) Automatic rudder test.
e) Transition Speed
6. Interface setup for Junction Unit and NI300X/CI300X if
installed (Page 90)
7. Perform settings in User Setup Menu page 31, for NAV
source, POS source and Compass source
8. Dockside Autopilot tests (refer to Operating Instructions,
page 13)
a) Test all stations (if applicable) - lock/unlock - active/
inactive
b) Test Non-Follow Up mode
c) Test Follow-Up mode
d) Test AUTO mode
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad AP20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad AP20 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info