575359

Silvercrest Z31622B - IAN 100926 Manual

11
Zoom out
Zoom in
Previous page
1/84
Next page
11 GB/IE
If the above instructions are not complied
with, the batteries may discharge them-
selves beyond their end voltage. There is
then a danger of leaking. If the batteries
have leaked inside your device, you should
remove them immediately in order to pre-
vent damage to the device!
Avoid contact with the skin, eyes and
mucous membranes. Any parts of the bo
dy
coming into contact with battery acid
should be rinsed off with copious amounts
of water and / or a doctor contacted if
necessary!
Preparing the product for use
Remove the insulation strip from the battery compartment
4
.
Replacing the batteries (Fig. B)
Open the battery compartment
4
on the back of the scale.
Remove the used batteries, if present.
Insert 2 x 1.5 V AAA batteries into the battery compart-
ment
4
.
Note: Make sure you fit the batteries the right way round
(polarity). The correct polarity is shown inside the battery
compartment
4
.
Close the battery compartment
4
.
Setting the time (Fig. A)
After you have inserted the batteries, the scale switches auto-
matically into the time mode
5
. As soon as the scale has
switched into the time mode
5
, the hour value flashes in the
LC display
1
. In this event, skip the next two steps.
If the scale is in the weighing mode, press and keep pressed
the MODE button
3
for approx. 2 seconds to switch into
the time mode
5
.
Press and keep pressed the TARE button
2
for approx.
3 seconds to set the time.
Press the MODE button
3
to set the desired hour value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting. Then the
minute value flashes.
Press the MODE button
3
to set the desired minute value.
Press and keep pressed the MODE button
3
to speed up
the value-setting process.
Press the TARE button
2
to confirm your setting.
Note: If you do not press another button within 60 seconds,
the set value stops to flash and the time is set.
Operation
Weighing (Fig. A)
If the scale is in the time mode
5
, press the MODE button
3
once to switch into the weighing mode.
Note: Shortly before the scale switches into the weighing
mode, the scale shows “HELO” in the display for 1–2 sec-
onds.
1. Place the kitchen scale on a solid, flat surface.
100926_silv_Digitale Kuechenwaage_Content_IE_FI_SE_DK_BE.indd 11 03.06.14 12:07
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest Z31622B - IAN 100926 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest Z31622B - IAN 100926 in the language / languages: English, German, Dutch, Danish, French, Swedish, Finnish as an attachment in your email.

The manual is 3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info