Manual Silvercrest SSB 36 A1 - IAN 113896 (page 30 of 38) (English, German, Dutch, French)

649224

Zoom out

Zoom in

1/38

DANGER! Risk of electric shock

~ Never put the device into operation if there are visible

damages to the device, the power unit or the cable or

if the device has been dropped before. Do not use the

device again, but have it checked by a specialist work-

shop.

~ Never open the casing of the device or power unit.

~ Connect the cable to the device before plugging the

power unit into a wall socket.

~ Only connect the power unit to a properly installed,

easily accessible wall socket, the voltage of which cor-

responds to the specifications on the rating plate. The

wall socket must continue to be easily accessible after

the device is plugged in.

~ Ensure that the cable cannot be damaged by sharp

edges or hot surfaces.

~ Ensure that the cable is not trapped or crushed.

~ When removing the power unit from the wall socket,

always pull the power unit and never the cable.

~ Pull the power unit out of the wall socket, …

…if there is a fault,

…before connecting the device to the power unit,

…before you clean the device and

…during thunderstorms.

~ In order to fully disconnect from the power supply, the

mains plug must be removed from the socket. Even

when switched off, a small amount of electricity is con-

sumed when the mains plug is plugged in.

~ To avoid any risk, do not make modifications to the de-

vice. Repairs must be carried out by a specialist work-

shop or the Service Centre.

Batteries

~ DANGER OF EXPLOSION! Be sure to ob-

serve the correct polarity when inserting the

battery.

~ Clean the battery and if necessary the device terminals

before you insert the batteries.

~ Batteries can be life-threatening if swallowed. There-

fore you should store batteries and the remote control

out of the reach of young children. If a battery has

been swallowed, medical assistance must be sought

immediately.

~ Batteries must not be charged or reactivated by other

means, nor must they be dismantled, thrown into a fire

or short-circuited.

~ Remove the batteries from the remote control if you do

not intend to use the remote control for a prolonged

period of time, or if the battery runs out of power. The

battery might leak and damage the remote control.

~ Do not subject batteries to extreme conditions, e.g. do

not place the remote control on radiators or expose it

to direct sunlight. Otherwise, there is an increased

danger of batteries leaking.

~ If battery acid has leaked, avoid contact with the skin,

eyes and mucous membranes. In case of contact with

the acid, rinse the affected area at once with plenty of

clean water and seek medical assistance immediately.

WARNING! Risk of material

damage

~ If you notice any irregularities (e.g. unusual noises,

strange smells or smoke developing), pull the power

unit out of the wall socket immediately. Do not use the

device any longer.

~ If the device is moved from a cold location to a warm

location, condensate may form in the device. Leave

the device switched off for a few hours.

~ Protect the device against damage, e.g. from:

- Heat, direct sunlight and open flames

- Impacts and similar violent effects

~ Candles and other open flames must be kept

away from this product at all times in order to

prevent the spread of fire.

~ Do not cover the power unit to prevent overheating.

~ Do not use any astringent or abrasive cleaning agents.

~ The device is fitted with non-slip plastic feet. As furni-

ture is coated with a wide array of varnishes and syn-

thetics, and is also treated with different care products,

it cannot be fully ruled out that some of these materials

contain ingredients that could attack and soften the

non-slip plastic feet. If necessary, place a non-slip mat

under the device.

~ Please ensure the following when mounting on a wall:

- The fixing material must be matched to the proper-

ties of the wall. If necessary, use fixing material other

than that supplied.

- Make sure that in the installation location there are

no pipes or cables in the wall (e.g. electricity, water,

gas).

- If necessary, have the wall mounting carried out by

an expert.

4. Items supplied

1Soundbar

1Power unit7

1Remote control

1CR2025 3 V battery (inserted)

1Stereo cinch cable8

2Screws28

2Rawlplugs29

1Drilling template30

1Operating instructions

In the case of incomplete delivery, please contact the re-

sponsible service centre of the manufacturer (see “Warran-

ty of HOYER HandelGmbH” on page 32).

Please observe the illustrations on the fold-out page.

BB58B%ERRN6HLWH)UHLWDJ-XQL

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SSB 36 A1 - IAN 113896 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,91 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Silvercrest SSB 36 A1 - IAN 113896 Manual

Product: