793239

Silvercrest SKM 2000 B2 - IAN 421470 Manual

10
Zoom out
Zoom in
Previous page
1/129
Next page
GB/IE/NI/CY/MT10
3. Before you start the device
3.1 Set up device
Remove all packaging materials and transport
protection from the unit.
To ensure that the unit operates safely and without
faults, the installation area must meet the following
requirements:
The floor must be firm, flat and level.
Minimum clearance distances of 50 cm to the side,
100 cm to the top, 50 cm to the rear and 50 cm to
the front of the case must be maintained.
Do not place the unit in a hot, wet or very humid
environment or near combustible materials.
The power socket must be easily accessible so
that the mains connection cable can be easily
disconnected if necessary.
Temperature range: 0 to +40 °C
Humidity (no condensation): 5–75 %
Please note: A slight odour may develop for a
short time during initial use.
3.2 Mount feet
Place the unit on a stable table on its rear side.
The lower edge of the case should protrude
slightly over the edge of the table.
Place a support stand 2 on the edge of
the bottom of the case. The two holes in the case
fit exactly on the holes in the support stand 2  .
Screw the support stand 2 in with 2 of the
screws 8
 
provided and hand-tighten. Do not
overtighten the screws 8!
2
Repeat the procedure with the second support
stand 2 .
Make sure that the support stands 2 are level
and firmly attached to the case.
Place the unit upright on its stands 2 .
4. Starting up
4.1 Switching the unit ON
Connect the unit to an earthed socket protected
by a residual current circuit breaker.
Now, set the toggle switch
4
  or
5
 
with your
desired heating level to the “On” position.
5 4
6 6
Please note: The indicator light
6
 
of the respec-
tive toggle switch 4
  resp.
5
 
used will turn on dur-
ing operation.
To set the maximum power of 2000 W, set both
toggle switches
4
  and
5
 
to the “On” position.
5 4
Please note:
The convector
1
 
only heats when the tempera-
ture control
7
 
has been turned clockwise until
an audible click is heard.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SKM 2000 B2 - IAN 421470 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SKM 2000 B2 - IAN 421470 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3.69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info