33
Signal Source “TV” (Analogue TV Reception)
EN
Signal Source “TV” (Analogue TV Reception)
The built-in receiver allows you to watch terrestrial analogue TV shows via an outdoor or indoor
antenna as well as TV shows from the cable TV network. To do this, connect the corresponding
antenna cable to the RF input (see page 10, item 14) on the right panel of your LT 1510. When us-
ing the device for the rst time you must program the analogue channels or perform an automatic
channel search.
Automatic Analogue Channel Search
With automatic analogue channel search, your LT 1510 will store all available analogue channels.
In order for the automatic analogue channel search to work properly, the signal source “TV” must be
selected (see page 19 - Selecting the Signal Source). Proceed as follows:
1. Press the INPUT button (30) on the remote control. The signal source selection menu will ap-
pear. Press the direction buttons (32) to select the signal source “TV”.
2. Press the MENU button (50) on the remote control, then press the direction buttons (32) and
OK to display the TV settings menu.
3. Press the direction button (32) on the remote control three times to navigate to the “TV” op-
tion and press to open it.
4. Press the direction button (32) on the remote control to navigate to the "Auto Tuning" option
and press to open it.
5. Select “Yes” and press OK on the remote control to launch the automatic channel search.
A window will display the current frequency band. A progress bar will inform you of the status of the
automatic channel search. All found stations will be automatically stored in a sequential list of chan-
nel presets.
After the search of the entire frequency band is completed, you’re done. Then the rst-found chan-
nel will be tuned-in. To cancel the process at any time, press OK (32) on the remote control.
If you had already performed an automatic channel search in the past, all existing pre-
set channels will be replaced by the new ones found.
