751715
23
Zoom out
Zoom in
Previous page
1/96
Next page
21
GB
4. Items supplied
1 hair and beard trimmer
1 power unit8
2 adjustable comb attachments1:
Attachment 1: 1/3/6/9/12/15 mm
Attachment 2: 18/21/24/27/30/
33 mm
1 comb12
1 scissors13
1 cleaning brush14
1 oil15
1 storage pouch16
1 set of operating instructions
5. Charging
NOTES:
Before the device is used for the first
time, and during the following charging
procedures, the device should be
charged for 90 minutes in each case.
When the batteries are almost empty,
the plug symbol6 flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Switch off the device with the on/off
switch4 if necessary.
2. Connect the power unit8 to the con-
nector7 of the device.
3. Insert the power unit8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. The plug symbol6 is lit red and the
battery is charged. When the battery is
fully charged, the battery symbol5
flashes in blue. When the battery is ful-
ly charged, the device can be used for
approximately 60 minutes without be-
ing connected to the power supply.
6. Operation
Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. Before switching to mains operation,
ensure that the device is switched off.
2. Connect the power unit8 to the con-
nection7 of the device.
3. Insert the power unit8 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. Switch on the device with the on/off
switch4.
6.1 Pushing on/removing the
comb attachments
WARNING! Risk of injury!
~Switch off the device before replacing
or changing the comb attachments1.
Pushing on
In order to attach a comb attachment1,
push this over the guide rails on the side
of the device onto the comb attachment
fastener9, until it is heard to click into
place.
Removing
1. Push the comb attachment
1
upwards us-
ing a moderate amount of force. The
comb attachment
1
is released from the
comb attachment fastener
9
.
2. Remove the comb attachment1.
6.2 Cutting hair
NOTES:
The hair to be dressed must be dry.
The cutting length may deviate depend-
ing on the cutting angle.
__315097_Haar und Bartschneider_B8.book Seite 21 Montag, 3. Juni 2019 1:40 13
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest IAN 315097 SHBS 500 D3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest IAN 315097 SHBS 500 D3 in the language / languages: English, German, Dutch, French, Polish, Swedish as an attachment in your email.

The manual is 2,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info