75475
21
Zoom out
Zoom in
Previous page
1/48
Next page
21
en
The appliance's water inlet filters must be cleaned with the tap is
open and no water flowing into the appliance.
The filters are located in the hose connection joining the water
supply pipe to the domestic water supply, and in the solenoid
valve connection at the back of the machine.
Procedure
1. First let the water pressure out of the supply pipe:
m Close the tap.
m Turn the programme selector to any wash programme
(except «Spin
» or «Pump b»
m Press the «Start » button. Allow the machine to operate for
40 seconds.
m Turn the selector to «Stop».
2. Loosen the supply pipe from the tap. Rinse the filter under
running water.
3. Reconnect the pipe to the tap fitting.
4. Remove the water supply hose from its connection on the
back of the appliance.
5. Remove the filter using flat pliers; wipe it and replace it.
6. Tighten and fit the pipe on its coupling.
7. Open the tap and check that there are no water leaks.
8. Close the tap.
If the machine has been installed in an area where it is not
protected against low temperatures, residual water must be
removed from the pump and the fresh-water hose after each
wash cycle.
Empty the water from the pump:
See the «Cleaning the pump» section.
Empty the water from the water inlet hose:
1. Close the tap.
2. Loosen the supply pipe from the tap. Place the end of the
hose in a container.
3. Select any wash programme for 40 seconds. Any water
remaining in the hose is drained.
4. Reconnect the pipe to the closed tap.
Wiping the appliance's
water inlet filters
Frost protection
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens WXB 1060 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens WXB 1060 in the language / languages: English, French as an attachment in your email.

The manual is 1,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info