473258

Siemens TJ10100 Manual

32
Zoom out
Zoom in
Previous page
1/131
Next page
32
Before calling the Technical Service
Problem Possible cause Solution
Hot air in the “ cold” This is not a fault! Residual heat. The hot air disappears after a
programme. short period of time.
The Start / Stop The start/stop button has been pressed It stops after 30 seconds or
light is flashing during an ironing cycle: pause function when start/stop is pressed.
The ironing programme blows Indicates that the cycle is
cold air for the last minute. finishing and the appliance
has begun to blow cold air.
Low air pressure in The ironing dummy has not been Fit the ironing dummy correctly.
the ironing dummy. fitted properly.
The air filter is dirty. Clean the air filter.
Faulty ironing dummy. Replace the ironing dummy.
Excessive air pressure The airbag is not fitted properly. Check the airbag adjustment in
the ironing dummy.
cords and adjust them correctly.
No air pressure in the The ironing dummy arms are twisted. Set the arms in the right
arms. position.
The airbag arms are not inside the Insert the airbag arms in the
ironing dummy arms. ironing dummy arms. Fig. 25.
Ironing process too long. The 10 A version was used. Switch over to the 16 A version
if possible.
The ends of the The end of the cord has splipped into Press the button band adjuster
adjustment cords used to the gap on the button band. in and pull on the cord.
regulate size have
become hooked up on
the appliance.
The fuse triggers when The wrong connection current has Select the right connection
the appliance is been selected. current. See “Changing the
connected. connection current”.
You hear a noise on This is because the internal tube is This is not a fault and does
raising or lowering the sliding not affect correct operation
appliance. of the appliance.
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens TJ10100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens TJ10100 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 3,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info