620382
47
Zoom out
Zoom in
Previous page
1/56
Next page
Landis & Staefa Division CC1B7865E February 10, 2000 47/56
9. Self-setting function
)
«
tunE»
is only possible in high-fire operation, in the «modulating burner» mode.
The self-setting function «
tunE»
is a pure software function unit that is integrated into
the controller. In the «modulating» mode of operation, «
tunE»
tests the response of the
controlled system to steps of the positioning signal according to a special procedure. A
complex control algorithm uses the response of the controlled system (actual value) to
calculate and store the control parameters for a PID or PI controller (set dt = 0!). The
«
tunE»
procedure can be repeated as often as required.
Self-setting Start
Identification of
the controlled
system
PID controller
settings
Controller
Controlled
system
Y
W
X
7865f09e/1199
The «
tunE»
function uses two different methods that are automatically selected
depending on the dynamic state of the actual value and the difference from the setpoint
at the start. «
tunE»
can be started from within any dynamic actual value sequence.
If there is a
large difference between actual value and setpoint
when «
tunE»
is
activated, a switching line is established around which the controlled variable performs
forced oscillations during the self-setting procedure. The switching line is set at such a
level that the actual value should not exceed the setpoint.
Switching
level
w
x
Start
t
7865d12e/1199
With a
small deviation
between setpoint and actual value, for instance when the
controlled system has stabilized, a forced oscillation is performed around the setpoint.
9.1 Self-setting function in high-fire operation
Two procedures
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens RWF40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens RWF40 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info