620382
56
Zoom out
Zoom in
Previous page
1/56
Next page
56/56 CC1B7865E February 10, 2000 Landis & Staefa Division
12. Actual settings
Parameter Display Factory
setting
Setting
Analog input 1, 2 and 3; setpoint
changeover / shift
C111
9030
Limit comparator; controller type;
setpoint 1; locking
C112
0010
Unit address; decimal place / unit,
signal for out-of-range
C113
0110
Measured value range start
analog input 1
1)
SCL
0
Measured value range
analog input 1
1)
SCH
100
Measured value range
analog input 2
1)
SCL2
0
Measured value range
analog input 2
1)
SCH2
100
Lower setpoint limit
1)
SPL
0
Upper setpoint limit
1)
SPH
100
Actual value correction,
analog input 1
1)
OFF1
0
Actual value correction,
analog input 2
1)
OFF2
0
Actual value correction,
analog input 3
1)
OFF3
0
Filter time constant for digital filter,
analog input 1
dF1
1
1)
These parameters are affected by the setting for the decimal place.
12.3 Configuration level
2000 Siemens Building Technologies AG
Siemens Building Technologies AG
Landis & Staefa Division
Berliner Ring 23
D - 76347 Rastatt
Tel. 0049 - 7222 - 598 - 0
Fax. 0049 - 7222 - 53182
http://www.landisstaefa.com
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens RWF40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens RWF40 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info