456798
9
Zoom out
Zoom in
Previous page
1/12
Next page
9/12
Siemens Building Technologies Product-Data Sheet Radio signal unit REV... CE1N2255en
Landis & Staefa Division 16.10..2000
Engineering notes controller / transmitter REV22RF
The unit should be located in the main living room (on the wall or free-standing using
the support provided):
The distance to the receiver should not exceed 20 m or 2 floors
The unit should be located such that the sensor can capture the room temperature
as accurately as possible, without getting affected by direct solar radiation or other
heat or refrigeration sources
The unit should be located such that it can transmit signals with as little interference
as possible. For this reason, the following points should be observed:
Do not mount the unit on metal surfaces
Not in the vicinity of electrical cables and equipment like PCs, TV sets,
microwave appliances, etc.
Not in the vicinity of large metal structures or construction elements with fine
metal meshes like special glass or special concrete
Engineering notes receiver REV-R.01/1
The unit should preferably be mounted near the controlled device
The unit should be located such that it can receive signals with as little interference
as possible. For this reason, the following points should be observed (same as with
the transmitter):
Not in control panels
Do not mount the unit on metal surfaces
Not in the vicinity of electrical cables and equipment like PCs, TV sets,
microwave appliances, etc.
Not in the vicinity of large metal structures or construction elements with fine
metal meshes like special glass or special concrete
The location where the unit is mounted should be dry and free from splash water
The unit can be fitted to most commercially available recessed conduit boxes or
directly on the wall
Mounting notes controller / transmitter REV22RF
When mounting the unit, the baseplate must first be fitted. Then, it must be engaged
at the top, swung downward and secured with a screw
For more detailed information, please refer to the Installation Instructions supplied
with the unit
Refer to the Installation Instructions (included in packing REV-R.01/1)
Mounting and installation notes receiver REV-R.01/1
The receiver must be wired with mains voltage switched off.
Mains voltage may be switched on again only after the unit is completely
mounted.
Wall mounting
Wall mounting
Support
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens REV22RF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens REV22RF in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens REV22RF

Siemens REV22RF User Manual - German - 2 pages

Siemens REV22RF User Manual - Dutch - 2 pages

Siemens REV22RF User Manual - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info