504662
2
Zoom out
Zoom in
Previous page
1/8
Next page
1
en
Gi
gaset
DA
210
/N
or
di
cs en
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_en.
f
m
/
16.06.2011
Gigaset DA210 overview
1 Speed dial key
2Mute key with LED
The LED flashes if the micro-
phone is switched off.
3Set key
The mute key LED flashes while
the telephone is in set mode.
4 Redial/Pause key
5Recall key
6Handset volume key
7 Switch for changing between
pulse and tone dialling mode
2
3
1
5
6
7
4
Call indica-
tor
flashes on
incoming
calls
Insert strip for
writing the
assignment of
speed dial keys
Slot to attach the
handset bracket
when mounting
the device on the
wall
2
en
Gi
gaset
DA
210
/N
or
di
cs en
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_en.
f
m
/
16.06.2011
Connecting the telephone
Safety precautions
When installing, connecting and
operating the telephone, always
observe the following precautions:
u Only use the jacks and leads sup-
plied.
u Only connect the connecting
lead to the intended socket.
u Only connect approved accesso-
ries.
u Lay the connecting lead where it
will not cause accidents.
u Position the telephone on a non-
slip surface.
u For your safety and protection,
the telephone may not be used
in the bath or shower rooms (wet
locations). The telephone is not
splash proof.
u Never expose the telephone to
sources of heat, direct sunlight or
other electrical devices.
u Protect your telephone from
moisture, dust, corrosive liquids
and vapours.
4
3
2
2
5
4
1
¤ Guide the cable through the
cable channel of the handset
cradle: upwards for operat-
ing the phone on the table
(2);
downwards when mount-
ing the phone on the wall
(3).
Wall mounting
¤ Drill two dowel holes into the wall at
a vertical distance of 85 mm and fix
two screws.
¤ Lift out the handset bracket (4) with a
screwdriver and clip it into the handset
cradle (5).
¤ Hang the telephone on the projecting
screw heads.
Please note: The handset bracket must be
placed in the cradle with the slanting edge
facing forwards (see graphic), as otherwise
the handset will not be properly secured.
¤ Connect your telephone to the main phone socket
using the supplied telephone cable and, if necessary,
one of the telephone adapters provided.
¤ Plug the coiled end of the
cable into the handset (1).
4
en
Gi
gaset
DA
210
/N
or
di
cs en
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_en.
f
m
/
16.06.2011
u Dialling a dialling pause after the
first 5 digits:
The portion of the number saved
after the pause is only dialled
after pressing the
I key.
Adjusting the telephone
Setting the handset volume
The handset volume can be set to
two levels.
F Press the handset vol-
ume control key.
The primary volume is reset after
hanging up.
Mute
You can deactivate the telephone's
microphone during a call.
C Press the mute key.
To reactivate microphone: Press the
mute key again or press any other
key.
The mute key LED flashes while the
microphone is deactivated.
Setting the ringer
You can set the ringer melody and
volume to 9 levels or turn it off
(factory default: level 6).
c K Lift the handset, press
the set key.
# Press the hash key.
Q ... O Press one of the
number keys.
(0: Ringer off until
handset is next lifted).
K Press the set key.
Note: The LED on the mute key flashes
while the telephone is in set mode.
Operation on a PABX
Special functions/Recall key
During an external call, you can
make an enquiry or forward the call.
To do this, press the recall key
H.
The subsequent procedure depends
on your PABX.
To set the recall key, the telephones
flash time must be set consistent
with your PABX. Please refer to the
operating instructions for your PABX.
Changing the dialling mode/
flash time
The telephone supports the follow-
ing dialling modes:
Depending on your PABX, you may
need to change your telephone’s
dialling mode or the flash time.
Temporary tone dialling switching
in "Pulse" position
To use functions that require tone
dialling (e.g. remote control of
answering machine), you can set the
telephone to tone dialling for the
duration of the call without adjust-
ing the switch.
After the connection is established:
* Press the star key.
After the connection is broken, the
setting reverts to pulse dialling.
T1: Tone dialling, flash time 100 ms
T2: Tone dialling, flash time 280/
600 ms
(depending on device model)
P: Pulse dialling
To so this, use the slid-
ing switch below the
keypad.
5
en
Gi
gaset
DA
210
/N
or
di
cs en
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_en.
f
m
/
16.06.2011
Operation on public
telephone systems
Public telephone systems - in some
cases by special order/request – offer
you a range of useful additional serv-
ices (e.g. call divert, call back on busy,
three-party conference etc.). These
services can be selected using speci-
fied key combinations, which your
network provider will notify you of.
You can save the entire key combina-
tion, including the number of a fixed
call divert destination, to your speed
dial keys just like a normal number.
Recall key
In public telephone systems, the
recall key is required to use certain
additional services; e.g. for "Call back
on busy".
You may need to adjust the flash
time of your telephone to the needs
of the public telephone system. To
do this, use the sliding switch below
the keypad (
£ page 4).
Appendix
Care
Wipe the unit with a damp cloth or
an antistatic cloth. Do not use sol-
vents or microfibre cloths.
Never use a dry cloth; this can cause
static.
Contact with liquid
If the device comes into contact with
liquid:
1 Unplug the power supply.
2 Allow the liquid to drain from the
device.
3 Pat all parts dry. Place the device
(the keypad facing down) in a
dry, warm place for at least 72
hours (not in a microwave, oven
etc.).
4 Do not switch on the device
again until it is completely dry.
When it has fully dried out, you will
normally be able to use it again.
In rare cases, contact with chemical
substances can cause changes to the
telephone's exterior. Due to the wide
variety of chemical products availa-
ble on the market, it was not possible
to test all substances.
!
6
en
Gi
gaset
DA
210
/N
or
di
cs en
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_en.
f
m
/
16.06.2011
Questions and answers
You lift the handset but you hear
no dialling tone: Is the connecting
lead correctly plugged into the tele-
phone and the telephone socket?
The dialling tone is audible but the
telephone will not dial: The con-
nection is OK. Is the dialling mode set
correctly?
The other party cannot hear you:
Mute activated?
Regular pulse noises can be heard
during a call: The connection is
receiving metering pulses from the
exchange, which the telephone can-
not interpret. Contact your network
operator.
Protecting our environment
Our environmental mission
statement
We, Gigaset Communications GmbH,
bear social responsibility and are
actively committed to a better world.
Our ideas, technologies and actions
serve people, society and the envi-
ronment. The aim of our global activ-
ity is to secure sustainable life
resources for humanity. We are com-
mitted to taking responsibility for
our products throughout their entire
life cycle. The environmental impact
of products, including their manu-
facture, procurement, distribution,
use, service and disposal, is evalu-
ated early on, during product and
process design.
Further information on environmen-
tally friendly products and processes
is available on the Internet at
www.gigaset.com
.
Environmental management
system
Gigaset Communica-
tions GmbH is certified
according to the inter-
national standards EN
14001 and ISO 9001.
ISO 14001 (Environment): Certified
since September 2007 by TüV SÜD
Management Service GmbH.
ISO 9001 (Quality): Certified since
17/02/1994 by TüV Süd Manage-
ment Service GmbH.
Contacts
If you should encounter any prob-
lems when operating the telephone
connected to a communication sys-
tem with analogue network access,
please contact the network operator
responsible or your dealer.
Authorisation
This device is intended for connec-
tion to analogue networks outside
the European Economic Area (with
the exception of Switzerland)
depending on national type
approval.
Country-specific requirements have
been taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other rel-
evant regulations laid down in Direc-
tive 1999/5/CE.
A copy of the 1999/5/EC Declaration
of Conformity is available at this
Internet address:
www.gigaset.com/docs
8
fr
Gi
gaset
DA
210 -
DA
310
/
/
03.06.2011
1
DE
Gi
gaset
DA
210
/
IM
-
N
or
d
/
A
30054-
M
6527-
R
201-1-
PG
19
/
DA
210_
IM
-
N
or
d
_
i
mpressum.
f
m
/
28.06.2011
Issued by
Gigaset Communications GmbH
Frankenstrasse 2a, D-46395 Bocholt
© Gigaset Communications GmbH 2011
All rights reserved. Subject to availability.
Rights of modification reserved.
www.gigaset.com
A30054-M6527-R201-1-PG19
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens Gigaset DA210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens Gigaset DA210 in the language / languages: English as an attachment in your email.

The manual is 0,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Siemens Gigaset DA210

Siemens Gigaset DA210 User Manual - German - 8 pages

Siemens Gigaset DA210 User Manual - Dutch - 10 pages

Siemens Gigaset DA210 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info