652196

Siemens DG12025 Manual

24
Zoom out
Zoom in
Previous page
1/32
Next page
16
Initial Use
Important!
Fill the reservoir and flush it out until water discharges from all hot water taps, otherwise the temperature sensor and
retainer will be damaged and require replacing.
During heating, displaced water must drop from the discharge of the safety valve (closed operation) or out of the mixer tap
(open operation). Monitor the first heating cycle.
Temperature Limits (page I, diagrams 2 to 4)
1. Set temperature selector to position ”
• ” and remove.
2. Remove the adjusting ring and reposition it so that 40°C or 60°C sits at reference point C on the display panel. Intermediate
positions are also possible.
3. Replace the temperature selector.
Maintenance
In order to avoid hazards, repairs may only be carried out by a customer service operator licensed by us.
The initial service through our customer service operator should take place around two years after the first operation. At this
time, the device will potentially be decalcified. Afterwards, the customer service operator will recommended a date for the next
service. Specify the E-No. and FD-No. when phoning the customer service operator!
Decalcification
Before decalcification the device must be emptied. Without placing stress on the device, draw hot water until cold water comes.
Then, close the shut-off valve on the intake, open the hot water valves on all connected fittings and empty the device via the
safety valve. A few litres of water will remain in the device. To empty completely, loosen the four screws on the cover and
remove the cover (page IV, diagram 13, 13.1). Unscrew the fastener “b” of the discharge connecting piece (page V, diagram
15), the remaining water flows away.
Decalcify the device. The specially enamelled steel reservoir and the protection anode are not to come into contact with the
decalcifier, do not work with a pump! Remove heater and de-calcify, clean discharge pipes mechanically and remove remaining
lime.
In an open operation, a valve can be fitted between the fitting and cold water intake of the reservoir to aid emptying.
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Siemens DG12025 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Siemens DG12025 in the language / languages: English, German as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info