Manual Shoprider W12 (page 12 of 24) (English)

600326

Zoom out

Zoom in

1/24

~12~

GETTING READY TO DRIVE

STEP 1 Press the On / Off Button, then the joystick will turn on after the Battery

Gauge blinks for about a second.

STEP 2 Press the Speed Increase / Decrease Button to set up a suitable level that

you can maneuver the Powerchair easily.

NOTE! The Powerchair will not move and the Battery Gauge will blink if you

push the joystick before or right after you turn the joystick on. To restore the

normal operating status, you have to release the joystick immediately back to

its center position. If you do not release the joystick within five seconds, the

Battery Gauge will flash rapidly. The Powerchair must be powered off and

then turned back on again.

STEP 3 Push the joystick to control the speed and direction of the Powerchair.

NOTE! Choose an area with plenty of space to ride the Powerchair. Select the

low level of the maximum speed setting until you are familiar with the controls.

In a short time you will be in total control and can then increase the speed in

steps.

STEP 4 Release the joystick whenever you want to stop the Powerchair.

ENGAGED / DISENGAGED MODE (Fig. 6)

In the event of a fault or battery failure, the electromagnetic brakes can be

disengaged allowing the Powerchair to be pushed. The levers should be switched to

the freewheel position according to the indication labels to set the Powerchair to the

Engaged / Disengaged Mode.

NOTE! Do not use or sit on the Powerchair when either of the brakes is

disengaged, or the joystick will not operate normally.

OPERATION INSTRUCTIONS

Fig. 6

Drive

Mode

(Engaged)

Free-wheel

Mode

(Disengaged)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Shoprider W12 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Shoprider W12 Manual

Product: