16
7. Installation to the bicycle
Install the levers to the handlebars. Then connect and adjust the brake and
shifting cables. Refer to the STI Lever Service Instructions for details on
these procedures.
* For the SC-6500-M, SC-6500-MX and SC-6500-T,
refer to the Service Instructions included.
(
1
)
Installing the signal cable (SC-6500)
Install the signal cable as shown
in Figure No1.
(
2
)
Installing the computer
Install the band and the bracket as
shown in Figure No2.
Tape the signal cable to the
handlebars.
(
3
)
Slide the computer onto the
bracket until it clicks into its
place.
as shown in Figure No3.
After this, wrap handlebar with
finishing tape around the
handlebars to secure both the
signal cable and the brake cable
Fig.1
Tightening torque:
0.3 - 0.5 Nm
{
2 - 4 in. lbs.
}
Fig.3
ComputerBracket
Fig.2
Bracket
Band
Tightening torque:
1 Nm
{
8 in. lbs.
}
