22
If the cassette has seven sprockets, press switch “A” once to change the
flashing “21” to “--”, and then press switch B once. This will indicate that
there is no 8th sprocket, and the operation for entering the number of
sprocket teeth will be complete.
If the cassette has 8 sprockets, enter the number of teeth for this position
and follow the same procedure as above to enter “--” in the 9th position
otherwise enter the number of teeth for the 9th sprocket.
Checking the number of teeth entered
Once the setting of number of sprocket teeth is completed, the display will
return to the initial input display. Re check all values by repeatedly
pressing switch “B” to
confirm each number of teeth. Press switch “B” once each time and check
whether the entered number of teeth are matching with the sprocket
position on the display.
If all values entered are
correct, press switch “B” for
2 seconds or more to
continue the next entry
procedure.
Press switch “B” for 2 seconds or
more to continue the next entry
procedure.
Fig.13
111 • • • • • for Traditional rear
derailleur
222
• • • • • for Rapid Rise Rear
derailleur (reverse
spring type)
(
6
)
Entering the type of rear derailleur
The display will change to that shown in fig 13. The display will change
from “111” to “222” each time switch “A” is pressed.
This Value
Indicated
Section
