770372
6
Zoom out
Zoom in
Previous page
1/14
Next page
1.Slowly lean the unit facing up/down on soft object.
2.Push the bottom cover into the base slot.
3.Use the screw to fix the bottom cover onto the base
of body (a small hole in the middle of the
bottom cover), then slowly lift up the unit.
How to Install
Installing the bottom cover
1.Install the washer, adjust the Adjustable Feet if
surface is not level. The distance between the
tub and cabinet should be the same (left & right,
front & back).
2.Distance between washer and wall should be at
least 5cm.
Placing the washer
Connect the drain hose to drain outlet, then secure
it with the metal clamp.
1. Do not seal the drain hose in the sewer pipe
to avoid poor drainage or no drainage.
2. In case of extending the drain hose, do not
exceed 3m to avoid long drainage time.
3. The height of the drain hose should not be
more than 10cm.
Installing the drain hose
Installing the water inlet hose
1. The joint of water inlet hose consists
of 2 parts, adapter and collar.
2. Pull down the collar of the inlet hose
to remove the adapter.
3. Loosen connectors A and B.
1.Length of the faucet needs to be at least 10mm, outer diameter needs to be 24mm and below.
2.Adapter can be removed If installed on a suitable faucet.
3.Spout of faucet should be smooth and round.
4.If spout of faucet is not flat, scrape it with rasp until it is flat.
5.Remove liner if outer diameter of faucet is too big.
5
Note
Note Do not place washer on stage to avoid overturn. When placing washer on carpet, make sure
carpet does not block air vents.
front/back
back/front
soft object
bottom cover
Distance between
dehydration tub and
cabinet should be same
adjustable
feet
metal clamp
adapter
adapter
adapter
collar
collar loop
nut
screw
about 5mm
liner
dehydration tub
cabinet
24
注意
5
重量 比例
14
宁波新乐电器有限公司
批准
会签
审核
标记处数 更改文件号
分区
设计
校对
制图
工艺
标准
341 2
D
AA
BB
CC
341 2
A
128克铜版纸
说明书
颜色
颜色 B
A
颜色
旧底图总号
技术要求:
1、商标:SHARP
2、尺寸:254X190.5mm
3.其余符合QB/XL20产品说明书技术标准
图文均为黑色
ESX705
Q6012P01SMSWJ
Q6012P01SMSWJ
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp ESX115 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp ESX115 in the language / languages: English as an attachment in your email.

The manual is 5.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info