485961

Sharp ER-A180 Manual

8
Zoom out
Zoom in
Previous page
1/180
Next page
6
GETTING STARTED
Follow these steps when you use the cash register for the first time.
Purchase and install three R6 or LR 6 batteries (“AA” size). The batteries prevent the data and user-
programmed settings from being erased, when the AC cord is accidentally disconnected or in case of a power
failure.
The batteries will last approximately one year. If the low battery symbol “ ” appears on the far left of the
display, you must replace within two days. And if the no battery symbol “ ” appears, you must replace them at
once.
To install the batteries, use the following procedure.
1. Turn the mode switch to the “OP X/Z” position.
The display will change to time display with the symbol “ ”.
2. Remove the printer cover.
Lift up the rear of the printer and detach it.
Be very careful with the manual cutter mounted on the
cover, so as not to cut yourself.
Initialize the Cash Register
In order for your cash register to operate properly, you must initialize the cash register before
programming for the first time. Use the following procedure:
Before initializing the cash register, make sure that the plug is not connected to the
outlet, and the batteries are not mounted in the register.
1. Turn the mode switch to the “PGM” position.
2. Insert the plug into the outlet.
The right most decimal point will blink for a few seconds, then the register will
sound three beeps and display “ 0.00” .
Unpack the cash register and place it in a location near a wall outlet. Be sure to locate it in such a
location as described in “IMPORTANT” (page 1).
To prevent the register from moving the drawer, fix the drawer with the fixing angle bracket. To fix the drawer,
please refer “Installing the fixing angle bracket” of “OPERATOR MAINTENANCE” (page 42).
OPX/Z
REG
MGR
PGM
X1/Z1
X2/Z2
REG
OPX/Z MGR
PGM
X1/Z1
X2/Z2
2
Install the Cash Register
1
Install Batteries
3
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp ER-A180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp ER-A180 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 3,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info