while in use.
● To prevent damage to the power cord,
- do not bend or kink the cable,
especially where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
● Do not place the appliance on any
surface sensitive to heat during or
immediately after use.
● Do not operate the appliance if it is
stored on the hanging loop.
● Make sure that the hot round brush is
kept well away from the scalp.
● When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
● Always switch off and remove the plug
from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
● This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
● Children should be supervised to ensure
that they do not play with the appliance.
● Caution: keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and not for commercial
applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Operation
Removing and changing the brush
attachments
To take off a round brush, first remove its tip
by turning it anti-clockwise, then slide off the
brush itself.
To fit a brush, slide it over its mounting,
attach the tip and turn clockwise to secure.
Switch positions
The appliance is equipped with a 3-position
switch allowing for the following settings:
Functions:
0 = Off
1 = Half power
2 = Full power
Use
-
The round brush is designed for shaping
the hair. To achieve this, the hair should
be divided into single strands (not too
thick) and then spread evenly over the
brush, turning them inwards or outwards
as desired.
-
Apply for a few seconds at a time only,
while letting the hot air take effect on the
hair.
-
Press the curl release button to roll the
brush out of the strands of hair.
-
Let the hair cool down sufficiently before
brushing it out.
General cleaning and care
● Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
● To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
-
If necessary, the housing may be wiped
with a dry lint-free cloth.
-
Remove all traces of loose hair from the
8
