Dear Customer,
Before using the appliance, the user must
read the following instructions carefully.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance.
Models with dual-voltage selector:
Models equipped with a dual voltage switch
can be set to different supply voltages by
using a screwdriver or similar object. Make
sure that the set voltage corresponds with
the supply voltage.
This product complies with the directives
which are binding for the CE-labelling.
Familiarisation
1. Brush tip
2. Round brush with long bristles
3. Curl release button
4. 3-position switch
5. Dual voltage selector
6. Air inlet openings
7. Hanging loop
8. Power cord with swivel
9. Round brush with short bristles
Important safety instructions
● Caution! Do not use the
appliance in the vicinity of a
bath, shower or swimming-
pool, over a washbasin filled
with water or any other receptacle
containing water.
● There is always a risk when the appliance
is operated near water even when it is
switched off. Therefore, if the appliance
is being used in a bathroom always
remove the plug from the wall socket
after use.
Additional protection is offered by fitting
an earth-leakage circuit-breaker with a
rated tripping current not exceeding
30mA into your bathroom installation.
Please consult a qualified electrician.
● Protect the appliance from moisture and
splashing water and do not operate it
with wet hands.
● Electric heating appliances operate at
very high temperatures. Do not touch
any part of the appliance except the
housing. Burns can occur from touching
the hot parts.
● Do not use the appliance on synthetic
hair-pieces or wigs. The heat emitted
might cause damage to the synthetic
fibres.
● Make sure the air intake and outlet
openings are not blocked by fingers or
hair and that no lint particles are allowed
to accumulate in the air intake.
● In case of a blockage, the overheating
protective device may switch the
appliance off. In this case, disconnect the
appliance from the mains power and
remove the blockage. Allow sufficient
time for the appliance to cool down
before it is switched on again.
● Before the appliance is used, the main
body as well as any attachment fitted
should be checked thoroughly for any
defects. Should the appliance, for
instance, have been dropped onto a hard
surface, it must not be used any longer:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
● The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
● Do not operate the appliance if excessive
force has been used to pull the power
cord. Damage cannot always be detected
from the outside; the entire unit should
therefore be checked by a qualified
technician before it is used again.
● Do not leave the appliance unattended
7
Hot-air hair curler
