Manual Severin WK 3422 (page 14 of 96) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish)

761747

Zoom out

Zoom in

1/96

142 x 208 mm

Thermal safety cut-out

The pre-set thermal safety cut-out protects the heating

element from overheating should the appliance be

erroneously switched on without any water, or if the heating

plate is calcied. Should this occur, all indicators are

ashing. In such a case, the appliance must be allowed to

cool down, or must be descaled, before it is switched on

again.

Automatic switch-off

∙ Unless the ‘keep-warm’ mode has been selected, the

kettle will switch off automatically around 3 minutes after

the last operation.

∙ In the ‘keep-warm’ mode, it switches off after 60

minutes.

∙ To re-activate the appliance, place the container on

the base, or press the buttons WATER START/STOP

or TEA START/STOP.

Before using for the rst time

∙ Unpack the appliance completely and remove all

packaging materials and stickers.

∙ To clean the kettle, boil (with the tea lter in place) and

discard the rst lling of water.

Operation

‘Silent’ function

∙ If the Tea Strength button is pressed for more than 3

seconds, the beep signals are deactivated. In this case,

all acoustic signals listed in these instructions are also

switched off.

∙ Pressing the button again for more than 3 seconds will

cancel the ‘Silent’ function.

General remarks

∙ Connect the appliance to the mains. A beep signal is

heard and the current water temperature in the container

(≥ 20 °C) is shown on the left in the display.

∙ The appliance is in stand-by mode and ready for use.

The display goes out after 3 minutes of non-use.

∙ To re-activate the appliance, place the container on the

base, or press the buttons WATER START/STOP or

TEA START/STOP.

∙When selecting temperatures below 100 °C, the

heating process takes place in steps, to ensure that the

temperature selected is not exceeded. In this case, the

heating phase will take a bit longer, but it also ensures

that the selected temperature is not exceeded, so that

the tea can develop its full aroma.

∙ If the current temperature inside the container exceeds

the temperature selected, the appliance cannot be

started.

∙ Temperatures below 40 °C cannot be selected.

Quick-boil function

When placing the water container onto the base and

pressing the WATER START/STOP button, the water is

heated to 100 °C without the need to set a temperature.

Pressing WATER START/STOP again stops the heating

process

Heating water

∙ Remove the water container from its base and open the

lid. Remove the tea lter.

∙ Fill the container with water to the desired level,

observing the Min (0.5 l) and Max (1.7 l for heating

water) markings.

∙ Close the lid.

∙ Place the container back on its base.

∙ Insert the plug into a suitable wall socket.

∙ The display shows the current water temperature inside

the container.

∙ Turn the KeepWarm control to select the desired

temperature.

∙Press the WATER START/STOP button. The button

lights up blue. The selected brewing temperature

(BREW TEMP) ashes briey in the display. The water

is now heated to the selected temperature. The current

water temperature is shown on the display.

∙ Once the pre-set temperature has been reached, the

WATER START/STOP button light goes out, three beep

signals are heard and the current temperature is shown

on the display.

∙ The appliance goes into stand-by mode. The kettle will

switch off automatically around 3 minutes after the last

operation.

∙ The boiling process may be interrupted by pressing the

WATER START/STOP button.

∙ To pour hot water, remove the container from its base.

∙ To prevent hot steam from being emitted, ensure that

the lid remains closed while pouring out the water.

∙ Do not leave any residual water in the container.

Making tea

Preparing the appliance

∙ Remove the water container from its base and open the

lid. Take out the tea lter by its ring, pulling it up with

gentle force.

∙ Fill the container with water to the desired level,

observing the Min (0.5 l) and Max (1.0 l for making tea)

markings.

∙ Take off the tea lter lid and put the required amount of

tea into the lter. Replace the lid, pushing it down.

∙ Fit the lter to the upper part of the mounting in

the container, so that its arms securely enclose the

mounting.

∙ Close the lid and replace the container on the base.

∙ Start tea preparation either by programme selection or

individual setting.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin WK 3422 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin WK 3422 Manual

Product: