360126
20
Zoom out
Zoom in
Previous page
1/124
Next page
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are caused by:
the electric motor within the compressor assembly; during
compressor start-up the sound level will be slightly higher for a
limited period of time.
the cooling agent flowing through the circuit.
The following table lists possible malfunctions, their probable causes and solutions. In the event of
operational problems, check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department.
Problem Possible cause and solution
The appliance is not working.
There is a power failure
The main fuse has blown.
The temperature control is set to ‘0‘.
The fuse in the wall socket (if applicable) has blown. This
can be checked by connecting another electrical device to
the socket and checking for function.
The temperature inside the
freezer compartment is not low
enough.
Too much food has been stored in the appliance.
The doors are not properly closed.
Insufficient ventilation: the unit is too close to a wall or
other structure or object.
The normal operating sound
changes or becomes louder.
Check for proper positioning (uneven floor?).
Are any adjacent objects affected by the running of the
cooling unit (i.e. caused to vibrate?)
Are there any objects on top of the unit which might be
vibrating?
Water is collecting on the
bottom of the unit.
The melt-water drain system is blocked. Remove the blockage
and clean the system.
Transporting the appliance
The unit must be transported only in its vertical position.
Do not tilt it any more than 45°. During transport, ensure that the unit is properly secured and
protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the plug
from the wall socket, the unit should be rendered unusable by cutting off the power cord
before being disposed of through special waste collection points in accordance with local
regulations. The refrigerant and the chemical agent in the insulation foam must be disposed of
through a competent agency. Take special care not to damage the cooling circuit before the unit is
handed over for competent disposal.
20
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin ks 9893 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin ks 9893 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info