Manual Severin KS 9864 (page 17 of 116) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish)

603075

Zoom out

Zoom in

1/116

air.

∙ To enable the melt-water to drain freely, always ensure that

the channel and discharge opening in the cabinet are free of

any blockage.

∙ Any water collecting in the bottom should be removed.

Energy saving tips

∙ The appliance should be set up in a well-ventilated, dry

room.

∙ Do not expose the appliance to direct sunlight, and do not

position it next to any heat sources (radiators, cookers etc.).

If this cannot be avoided, however, suitable insulation must be

installed between the heat source and the unit.

∙ Ensure sufﬁ cient air circulation around the sides of the unit.

∙ The compressor (at the rear) should be cleaned at regular

intervals. Accumulated dust causes an increase in energy

consumption.

∙ Warm food should be allowed to cool down before it is

stored inside.

∙ To prevent an increased build-up of ice, do not leave the

doors of the unit open for too long when loading or taking

out food.

∙ Frequent de-frosting helps to save energy. For detailed

information on cleaning the appliance, please refer to the

section De-frosting and cleaning.

∙ Do not set a lower-than-necessary temperature. For detailed

information on the temperature settings, please refer to the

section Temperature control.

Operating noise

∙ Certain typical sounds can be heard when the appliance is

switched on. These sounds are:

∙ caused by the electrical

motor within the

compressor assembly;

during compressor

start-up the sound level

will be slightly higher for

a limited period of time.

∙ caused by the cooling

agent ﬂ owing through the circuit.

Trouble-shooting

The following table lists possible malfunctions and their

probable causes and solutions. In the event of operational

p roblems, check ﬁ rst whether a solution can be found using this

table. If the problem persists, disconnect the appliance from the

mains power and contact our Customer Service Department.

Problem Possible cause and solution

The appliance is not working at all. ∙ The temperature control is set to ‘0’.  Use a higher temperature setting.

∙ The wall socket is defective.  Check the fuse. If necessary, have the wall outlet

checked by a qualiﬁ ed electrician.

The temperature inside the refrigerator

cabinet or freezer compartment is not

low enough.

∙ Too much food has been stored in the appliance.  Do not store excessive food (see

product data sheet).

∙ The doors are not properly closed.  Ensure that the doors are properly closed.

∙ The door seals are defective.  Check the door seals and contact our Customer

Service if necessary.

∙ There is too much dust on the condenser.  Clean the condenser regularly.

∙ Insufﬁ cient ventilation: the unit is too close to a wall or other structure or object. 

see section ‘Ventilation’.

∙ The temperature control is set too low.  Use a higher setting.

The normal operating sound changes

or becomes louder.

∙ The unit is not ﬁ rmly set on the ﬂ oor.  Use the adjustable front feet to align the unit

properly.

∙ Adjacent furniture or objects are affected by the running of the cooling unit (i.e. causing

them to vibrate).  Keep the stated clearances.

∙ Any objects on top of the unit might be vibrating  Remove such objects.

Water is collecting on the bottom of

the unit.

∙ The melt-water drain system is blocked.  Remove the blockage and clean the

system.

Excessive build-up of frost on the rear

of the main cabinet.

∙ Hot food has been stored inside the cabinet.  Let the food cool down before putting

it in.

∙ The door seals are defective.  Check the door seals and contact our Customer

Service, if necessary.

∙ The temperature control is set too high.  Use a lower temperature setting.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9864 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Severin KS 9864 Manual

Product: