603075
15
Zoom out
Zoom in
Previous page
1/116
Next page
15
transport damage, including its power cord.
Clean the unit as described in the section De-frosting and
cleaning.
When the unit is rst switched on, a slight ‘new’ smell may
be noticed. However, this will disappear once the cooling
process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in conditions where the relative
humidity is no more than 70 %.
Refrigeration appliances are classi ed into certain
climate classes. This classi cation indicates the ambient
temperature at which the device can be operated. Please
refer to the product data sheet for information on the
classi cation for this unit; the data sheet can be found at the
end of this manual.
Do not use the appliance outdoors.
Ensure that the plug is accessible and can be removed from
the wall socket at any time.
Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
In the case of uneven oors, the adjustable front feet on the
unit can be used to compensate and ensure optimum stability.
If the unit is installed next to a wall, a minimum lateral
distance of 225 mm is necessary, so that the doors can open
wide enough for the drawers to be taken out.
Set-up dimensions
Ventilation
Ensure that there is enough space around the unit so that the
air circulation round and behind it is not obstructed. (Rear,
sides and top 100 mm.)
Temperature control
The unit is re-activated by connecting it to the mains. It
is only switched off completely when the plug is removed
from the wall socket. In position ‘0’, the cooling function is
switched off, though the appliance is still connected to the
mains.
The temperature in the refrigerator cabinet can be adjusted
by setting the temperature control. Turning the control
clockwise will decrease the temperature, while turning it anti-
clockwise will increase it.
The medium settings are usually most suitable for home
use.
We recommend using a thermometer to check the actual
temperature inside the cabinet and make adjustments as
necessary.
Following a power interruption, or if the unit has been
switched off on purpose, it may take around 5 minutes
before it switches on again.
Interior lighting
Caution: Do not remove the cover of the interior LED light. If
there should be any malfunction, please contact the customer
service for assistance.
Storing and freezing food
The temperatures inside the refrigerator cabinet and freezer
compartment depend mainly on the ambient temperature, the
temperature control setting and the amount of food stored. It
should also be noted that the interior temperature may increase
every time the door is opened.
Main cabinet
Different areas of the refrigerator cabinet are affected
differently by the cooling effect. The warmest area is around
the door in the higher part of the cabinet, the coldest around
the rear wall and in the lower part of the cabinet.
The food should therefore be stored as follows:
On main cabinet shelves (from top to bottom): bakery items,
ready meals, dairy products, meat, sh and cold meats/
sausages.
In the vegetable compartment: vegetables, salad and fruit.
In the door (from top to bottom): butter, cheese, eggs, tubes
(eg mustard), small bottles, large bottles, milk and fruit-juice
tetra-packs.
In the Zero-degree zone: perishable foods - vegetables,
meat, sh and dairy products
Liquid or strong-smelling food, or food which is likely to
absorb strong odours (e.g. cheese, sh, butter), should be
stored separately or in hermetically sealed containers.
Warm food should be left to cool down to room
temperature before being placed in the refrigerator.
Always ensure that the door is properly closed and that the
seal is not obstructed by food stored inside the cabinet or
door.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9864 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9864 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info