556602

Severin KS 9761 Manual

23
Zoom out
Zoom in
Previous page
1/52
Next page
around the rear area. This layer of frost will start melting when the compressor is not working.
Through a system of hoses, the melt-water drains into the collection tray below the compressor, where
it will be absorbed into the surrounding air. The unit does not therefore require de-frosting, but only
proper cleaning instead.
To enable the melt-water to drain freely, always ensure that the channel and discharge opening in
the cabinet are free of any blockage.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are:
– caused by the electrical motor within the compressor assembly;
during compressor start-up the sound level will be slightly higher
for a limited period of time.
– caused by the cooling agent flowing through the circuit.
The following table lists possible malfunctions and their probable causes and solutions. In the event
of operational problems, check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department.
Problem Possible cause and solution
The appliance is not working
at all.
– There is a power failure
– The main fuse has blown.
– The temperature control is set to ‘0‘.
– The fuse in the wall socket (if applicable) has blown. This can
be checked by connecting another electrical device to the
socket and checking for function.
The temperature inside the
freezer compartment is not
low enough.
– Too much food has been stored in the appliance.
– The doors are not properly closed.
– There is too much dust on the condenser.
– Insufficient ventilation: the unit is too close to a wall or other
structure or object.
– The temperature control is set too low.
The normal operating sound
changes or becomes louder.
– Check for proper positioning (uneven floor?).
– Are any adjacent objects affected by the running of the
cooling unit (i.e. causing them to vibrate?)
– Are there any objects on top of the unit which might be
vibrating?
23
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Severin KS 9761 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Severin KS 9761 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info